Owner's Manual

ManualsBrandsManitowoc ManualsAccessoriesManitowoc Water Filtration Kit for Manitowoc Machines

Installation Checklist

• Have the min.-max. water temperature and pressure been

checked?

• Has the filter system been installed away from heavy traffic

areas?

• Is the system installed securely to the mounting surface?

• Has the water supply line been checked for suitability? (Refer

to Water Service section, page 7).

• Have the water supply lines been securely installed into the

inlet/outlet ports?

Start-Up Procedure

Turn on the incoming water supply.

Check for leaks. If the connections are leaking, refer to the

Troubleshooting section of this manual (page 11) to reinstall.

NOTE: System should be flushed for 2 minutes to remove trapped

air and carbon fines (5 minutes for AR-Pre).

To set the pressure gauge:

Rotate the red follower needle clockwise until it contacts the black

pressure needle on the low side.

The red follower needle will now record the lowest water pressure

when the filter system is in use.

NOTE: The filter pressure will decrease as the cartridge life decreases.

Section 3

Routine Maintenance

ArcticPure

cartridges will need to be changed for one or more of

the following reasons:

• The filter has trapped water-borne sediment and the water

flow has stopped or water pressure through the filter has

dropped below 20 psi.

• The maximum life of the carbon filter has been reached and

the filter will no longer reduce chlorine to acceptable levels.

• The scale inhibitor has been completely dissolved and hard

scale build-up may accelerate.

It is recommended that ArcticPure

filter cartridges be changed out:

• Every 6 months or when water pressure through the system

drops below 20 psi, whichever occurs first.

To change the filter:

1. Rotate the cartridge 1/4 turn to the left. The cartridge should

easily release. Dispose of used cartridge.

2. Remove the protective cap from the cartridge.

3. Inspect the cartridge and o-rings for damage. See Replacement

Parts list if replacement is required.

4. Lubricate o-rings with food grade lubricant.

5. With the product label facing to the left, insert the cartridge

into the filter head. Rotate 1/4 turn to the right to secure.

Product label will face forward.

ArcticPure

systems are equipped with internal shut-off valves.

It is not necessary to shut off the incoming water supply

during cartridge changeout.

DO NOT use petroleum jelly.