User Manual

Part Number 000009036 8/13 13
Determine Type of Solution Needed
,
Caution
Use only Manitowoc approved Ice Machine Cleaner
& Sanitizer. It is a violation of Federal law to use these
solutions in a manner inconsistent with their labeling.
Read and understand all labels on the bottles before
use.
The AuCS® accessory will dispense Cleaner OR Sanitizer. It
cannot dispense both at the same time.
MANITOWOC ICE MACHINE CLEANER
Part Number 94-0546-3
Ice Machine Cleaner is used to control buildup and to
remove lime scale or other mineral deposits. It will not
“sanitize” the ice machine.
It is recommended for use in places that have lime scale or
other mineral deposits, but no problems with slime.
Model Amount of Cleaner Dispensed
22" or 30"
IceMachine
3 oz (88 ml)
48" Ice Machine 6 oz (177 ml)
MANITOWOC ICE MACHINE SANITIZER
Part Number 94-0565-3
Ice Machine Sanitizer is used for sanitizing and controlling
algae buildup (slime) and other bacterial growth. The ice
machine (and bin or dispenser) must be sanitized on a
regular schedule, following Manitowoc recommendations
and local regulations.
It is recommended for use in places such as pizzerias, bars,
bakeries, etc., that have airborne bacteria (yeast). Sanitizing
is also recommended in places that do not have lime scale
(or other mineral deposit problems).
Model Amount of Sanitizer Dispensed
22" or 30"
IceMachine
3 oz (88 ml)
48" Ice Machine 6 oz (176 ml)
Hose Priming
The dispenser pump requires priming after initial
installation, or if the hose between the AuCS® reservoir and
pump has been pumped dry or the tubing between the
AuCS® pump and the ice machine has been pumped dry.
n
Warning
Do not blow into or suck on the hose in an attempt to
prime it.
Perform the following procedure:
1. Press the CLEAN button.
2. The water pump and dump valve will turn on. The
dump valve will shut off after approximately 45
seconds.
3. The control waits until water contacts the water level
probe then energizes the AuCS® pump (22" or 30" ice
machines - 30 seconds, 48" ice machines - 60 seconds).
4. Allow the ice machine to complete the cleaning or
sanitizing cycle. Refer to “Manual Start Operation” for
details.
Important
The priming procedure starts the automatic cleaning
mode. After starting an ice making cycle, the ice machine
will run through 6 rinse and dump cycles before making
ice.
Section 3
Operation