Owner's Manual

Part Number: 000013325 Rev 02 6/17 11
Section 2 Installation
Bin Installation
NOTE: When using casters, the units must be tethered or
secured to comply with all applicable codes. Swivel casters
must be mounted on the front and rigid casters must be
mounted on the rear. Lock the front casters after installation
is complete.
1. Remove threaded plug from drain fitting.
2. Screw the leveling legs onto the bottom of the bin.
3. Screw the foot of each leg in as far as possible.
4. Move the bin into its final position.
5. Level the bin to assure that the bin door closes and seals
properly. Use a level on top of the bin. Turn the base of
each foot as necessary to level the bin.
6. Inspect bin gasket prior to ice machine installation.
(Manitowoc bins come with a closed cell foam gasket
installed along the top surface of the bin.)
7. Remove all panels from ice machine before lifting and
installing on bin. Remove both front panels, top cover,
left and right side panels.
Air Baffle
Self-Contained Air-cooled Only
The air-cooled baffle prevents condenser air from
recirculating. To install:
1. Loosen the back panel screws next to the condenser.
2. Align the keyhole slots in the air baffle with the screw
holes and slide the baffle down to lock in place.