Owner's Manual

26 Part Number: 000013325 Rev 02 6/17
Installation Section 2
Remove Ice Thickness Probe Shipping Brackets
Remove and discard shipping brackets before starting the ice
machine.
Starting the Ice Machine
Step 1 Refer to cleaning and sanitizing procedure and
sanitize the ice machine and bin before placing in operation.
Step 2 Press the power button to start ice-making.
NOTE: The water curtain/ice damper(s) must be in place on
the evaporator before the ice machine will start.
Refer to the sequence of operation in Section 3 for further
operational details.
Step 3 Observe a freeze and harvest cycle, then perform
an ice thickness check.
MINIMUM/MAXIMUM SLAB WEIGHT
Adjust ice thickness to meet chart specifications.
Model
Minimum
Ice Weight Per
Cycle
lbs
Grams
Maximum
Ice Weight Per
Cycle
lbs
Grams
i300
2.40 lbs
1089 grams
2.80 lbs
1270 grams
i320 - i450 - i520
3.40 lbs
1542 grams
3.90 lbs
1769 grams
i500 - i680 - i686 i690 - i696
4.60 lbs
2087 grams
5.20 lbs
2359 grams
i600 - i606
4.12 lbs
1869 grams
4.75 lbs
2155 grams
i850 - i870 - i890 - i976
5.75 lbs
2608 grams
6.50 lbs
2948 grams
i906 -i1000 - i1006 - i1070
6.2 lbs
2812 grams
7.2 lbs
3266 grams
i1200
7.50 lbs
3402 grams
8.20 lbs
3719 grams
i1090
7.50 lbs
3402 grams
8.50 lbs
3856 grams
i1400 - i1406
10.25 lbs
4649 grams
11.50 lbs
5216 grams
i1470
12.0 lbs
5443 grams
14.0 lbs
6350 grams
i1800
13.20 lbs
5987 grams
14.80 lbs
6713 grams
i1870 - i2170 - i2176
15.5 lbs
7031 grams
16.75 lbs
7598 grams
Ice Thickness Check
After a harvest cycle, inspect the ice cubes in the ice storage
bin. The ice thickness probe is factory-set to maintain the ice
bridge thickness at 3 mm (1/8").
NOTE: Make sure the water curtain is in place when
performing this check. It prevents water from splashing out
of the water trough.
1. Inspect the bridge connecting the cubes. It should be
about 3 mm (1/8") thick.
2. If adjustment is necessary, turn the ice thickness probe
adjustment screw clockwise to increase bridge thickness,
counterclockwise to decrease bridge thickness. Set at
7 mm (9/32") gap between ice thickness probe and
evaporator as starting point, then adjust to achieve a 3
mm (1/8") bridge thickness.
NOTE: Turning the adjustment one-third of a turn will change
the ice thickness about 1.5 mm (1/16").
3 mm (1/8")
ICE BRIDGE THICKNESS
PLACE 7 mm (9/32") DRILL BIT HERE
BETWEEN PROBE AND EVAPORATOR
TO SET INITIAL GAP
ADJUSTING SCREW
Ice Thickness Check
Make sure the ice thickness probe wire doesn’t restrict movement
of the probe.