Owner's Manual

ManualsBrandsManitowoc ManualsModularManitowoc Indigo 30" 310 Lbs Daily Half Dice Modular Commercial Ice Machine - Less Storage Bin

Part Number: 000013325 Rev 02 6/17 43

Section 4 Maintenance

MULTIPLE EVAPORATOR ICE MACHINES

A. Remove front evaporator shield

• Remove four quarter-turn connectors.

• Remove splash shield.

B. Remove left and right evaporator top covers

• Remove two thumbscrews from the front of each

evaporator top cover.

• Lift front of cover, pull forward to remove.

C. Remove splash shields

NOTE: Each evaporator has a splash shield that must be

removed - total of four splash shields.

• Grasp the top center of splash shields.

• Lift up and then out.

D. Remove ice thickness probe

• Compress the hinge pin on the top of the ice thickness

probe.

• Pivot the ice thickness probe to disengage one pin then

the other. The ice thickness probe can be cleaned at this

point without complete removal. If complete removal is

desired, disconnect the ice thickness control wiring from

the control board.

E. Remove the water pump assembly

• Disconnect the vinyl distribution tube from both water

pumps.

• Disconnect the water pump and water level probe

electrical connections.

• After the wires are disconnected, remove the two

thumbscrews and lift the water pump assembly out of

the ice machine.

• Remove the thumbscrews securing the water pumps (2

each pump) and remove water pumps. Do not immerse

the water pump motor in cleaner or sanitizer solutions.

• Remove the water level probe from the assembly

housing.

F. Remove the water trough

• Pull forward on the water trough to remove.

G. Remove distribution tubes

NOTE: Each evaporator has a distribution that must be

removed - total of four distribution tubes.

• Thumbscrews for the distribution tube are retained

to prevent loss. Loosen thumbscrews, but do not pull

thumbscrews out of distribution tube.

• Loosen the two outer screws and pull forward on the

distribution tube to release from slip joint.

• Disassemble distribution tube by loosening the two (2)

middle thumbscrews and dividing the distribution tube

into two pieces.

H. Remove ice dampers

NOTE: Each evaporator has an ice damper that must be

removed - total of four ice dampers.

• Grasp ice damper and apply pressure toward the back

mounting bracket.

• Apply pressure to the front mounting bracket with

thumb.

• Pull ice damper downward when the front ice damper

pin disengages.

A E