Jet Scream 3 hybrid powered B/G vehicle One of the latest breakthroughs in the manufacture of real automobiles is something called “Hybrid power technology”. These cars are powered by two. separate energy systems. One system is an internal combustion (gasoline; engine and the other power source is rechargeable batteries and an electric motor. The purpose of combining these two energy sources is to make a car that has excellent fuel canary AND enough reserve power to let it caller ata quickly in traffic.
General praetor description Jet Scream vehicle (Fig 1) Pressure cap Air pump valve Pressure relief valve Valve reset lever Water tank Air Pump (Fig 2) 5 8. Radio antenna Air pump valve seat 12. Air pump handle flocks motor nozzle S.8Y Ni-Cad battery box . Steering trim adjustment lever 10. ON/OFF switch RIC controller Fig 3) 13. Right/left lever 14, Forwardness lever 15. Antenna 16. Rocket slant button 17. Rotate blast shield 8. ON/OFF switch 18, LED power indicator 200.
Uehiuie set ap You will need 0 supply a fully charged Ni cad battery pack to make the Jet Scream un. These are very commonly available at mast toy stores and are made by manufacturers such as Nikki or Early light, Tess will work perfectly for your vehicle. If you purchase a Ni-cad pack from a hottie store, DO NOT select one with 2 value greater than 800ma/hour.
aor Take the Jet Car to a ‘cation that will allow you to SAFELY play with It in a large open ares. A play: ground, unused parking for, or open field with a flat surface will work wall. Try to avoid areas that have concrete barriers, walls, ar hard obstacles NEVER play with your Jet Scream vehicle in a strata where cars, bicycles, people or animals may be, as this nan be highly dangerous.
Steering trim adjustment Each Jet Scream car may require some ! small adjustment from you to make restraint ine. If you car is making a constant tur to right or left when yau are tying 10 move straight, you can use the Steering Trim Adjustment Lever to try to correct it. Simply move the lever in the opposite direction and ty to run the vehicle again until the vehicle goes straight {Fig 12 NOTE: Different surfaces will affect how well your car goes in & straight fine.
NOTE: ¥f you see water squirting out of the Rocket Nozzle on the back of the vehicle, move the Valve Set Lever hack 10 the horizontal position again 7) Pump the Ar pump shout 20 to 25 times. You will feel that the handier becomes difficult te move. This is normal. Do not try 1 pup mare that 25 times as the internal Pressure Relief valve will bides off any additional pressure, 8) Hem ova the Alr Pump by unscrewing the Air Pump Valve Seat coi clockwise.
Overheating alarm ft is possible that the high-powered electric miter can become overheated when used in a hat environment or during a high level of continuous use. To Prevent permanent damage to the miter, a heat sensor has been installed 10 shut the vehicle off and allow the motor to coo! wham the temperature goes tag high if
Cleaning the vehicle Dn not place the vehicles in water. Remove the Ni cad batteries before any cleaning. Use ONLY use a damp rag or cloth ta rub any dirt off from the body ar chassis. Do not use any “Spray” cleaners as this may damage the elev: tonic circuits. Special tiles abut Bi-pad battering The Ni-cad batteries will last about 15 tn 20 minutes in normal continuances play provided the Ni-ed batteries are in good operating condition and were charged proper.
Trouble shooting Difficulty My car did not eject any water. My car is cloaking water from the nozzle when {pump it. My car ejects only 2 small amount of water from the tank. My car did aot run mots than 5 minutes before significantly slowing down. Make sure the tank fully energized and the “jet” motor sound was heard, Check to ses that only ordinary tap water was used in the tank. Make sure that you are moving the Reversibility button to the FORWARD position while pressing the Blast Button AT THE SAME TIME.
Difficulty Solution My car tends to not go in a straight line. Use the Steering Trim Adjustment Lever to make any corrections. hear a "hissing"sound from the top of the 1} Check to see if the Orange Water Cap is on tightly. vehicle 2) Don't pump the tank more than 25 times of the pressure relief naive will begin to open. My car slows down significantly when | play for This is normal.Remove the Ni-cad battened and replace them with a about 15 to 20 minutes. {sully charged set.
Warning review WHEN FILLING THE TANK, BE CAREFUL TO NOT HIT THE ANTENNA WITH YOUR EYE. NEVER PUT ANY LIQUID OR CHEMICAL OTHER THAN PLAIN TAP WATER IN THE TANK. NEVER RUN THE VEHICLE WHERE IT MAY HIT OBJECTS, PERSONS, OR ANIMALS. NEVER PRESSURIZE THE TANK WITH ANY METHOD OTHER THAN THE SUPPLIED RAND AIR PUMP NEVER TOUCH THE AREA NEAR THE MOTOR IMMEDIATELY AFTER THE VEH! CLE HAS BEEN RUN. THIS AREA MAY BE HOT.