Owner`s manual

POWER:

Outboard Power Supply is factory set for 100V, 120V or 220-240VAC operation

for original destination country's mains voltage.

Operating Mains Voltage: 120 to 240VAC operation changeable with power transformer re-wiring via

internal switch and fuse value change.

100VAC operation changeover achieved via rewiring of power transformer PCB.

Mains Voltage Frequency: 50~ 60Hz

Mains Fuse Value: 1.5A SLO-BLO for 100 or 120V operation

Mains Fuse Value: 0.75A SLO-BLO for 220V to 240V operation

Do not use FAST BLOW fuses.

Power consumption: 0.8A @ 120V = 96 watts

PHYSICAL:

Dimensions: 19" W x 5.25" H x 13" D

Unit Weight: WAVE = 23 lbs.; PSU = 15 lbs.

Shipping Weight: 49 lbs.

ANALOG SECTION:

INPUT SENSITIVITY: 494mV (-3.9dBu) yields 1V out

INPUT IMPEDANCE: 50Kohms

MAXIMUM INPUT LEVEL: 9.75Vrms produces 19.86V on output at 1KHz before clipping

+22dBu produces +28.18dBu on output at 1KHz before clipping

MAXIMUM GAIN: 12 dB

MAXIMUM OUTPUT: +30 dBu, 25 V rms (70V P-P) (+31dbu @ 1.5% THD)

+8.25 dBu digital full scale (2.0 V Rms)

FREQUENCY RESPONSE: 20 Hz to 20 kHz +/- .5 dB

8 Hz to 45 kHz +/- 3 dB

THD+N: 0.015% 20Hz - 20KHz bandwidth

NOISE FLOOR -88 db (20 Hz - 20 kHz) (-90 A-Weight)

S/N 120 dB analog (96 db digital)

L/R Volume Control Matching .2 dB (from -50 to max)

REMOTE CONTROL RANGE MEASUREMENTS:

Measurements done with new set of batteries.

If the remote is closer than 9 feet, the maximum angle response is around

60 to 75 degrees which is the counter sink angle of the receiver's hole in the front panel.

Distance of 9-10 ft, the maximum angle is 65-75 degrees.

Distance of 12 ft, the maximum angle is 60 degrees.

Distance of 13 ft, the maximum angle is 45-55 degrees.

Distance of 16 ft, the maximum angle is 45 degrees.

Distance of 20 ft, the maximum angle is 25-35 degrees.

Distance of 25-27 ft, the maximum angle is 0-15 degrees.

This is the maximum distance-angle the remote will do.

MORE SPECIFICATIONSMORE SPECIFICATIONS

MORE SPECIFICATIONS