User manual

BUMBLE-BEE
¿
MM209
9
 Do not stick labels or tape on the discs, and do not
scratch or damage the discs.
 The disc spins at a high speed during playback.
Do not use damaged, cracked, or warped discs
because they could damage the unit.
Disc Cleaning
 Fingerprints or dirt on disc surfaces can weaken
the light reected from the disc and directly inuen-
ce the signal quality. The poorer the signal quality,
the poorer the playback performance. Keep the disc
clean by wiping it straight out from the center with a
dry soft cloth.
 If the disc is very dirty, wipe with a moist soft cloth,
then follow with a dry soft cloth.
 Do not use record cleaning sprays, benzene, thinner,
anti-static electricity liquids, or any other solvent.
These may damage the disc surface.
Disc Storage
 Please keep the discs in their original cases to avoid
bending the discs. Do not keep discs in locations
with high temperature, high humidity, or direct sun-
shine. These conditions may also cause damage
to the discs.
 Carefully read all instructions on the disc label.
Power Supply
AC power operation
Connect one end of the mains lead to (AC-In) socket
and the other end to an AC outlet.
Battery power operation
 Open the battery compartment lid by pushing down
on the tabs.
 Install 6 x “UM-1” size batteries (not supplied). Refer
to the polarity diagram in the battery compartment of
the unit. Match the (+) and (–) marks on the diagram
to the (+) and (–) marks on the batteries.
Caution! When installing batteries
To prevent battery electrolyte leakage, which may result
in injury and damage to the unit or other objects, observe
the following precautions:
 All batteries must be installed with the proper polarity
(see diagram in the compartment of the unit).
 Do not mix new with old or used batteries.
 Only use batteries of the same type and brand.
 Remove the batteries when they are not to be used
for a long period time.
Cassette Operation
 Press the STOP/EJECT button to open the
CASSETTE DOOR.
Then insert a cassette tape into the cassette compart-
ment andclose the cassette door.
Playback of Cassette
1. Set the FUNCTION SWITCH to TAPE position.
2. Press PLAY button rmly down until locked.
3. First press STOP/EJECT button and then press
FAST FORWARD button to fast forward the tape.
4. First press STOP/EJECT button and then press
REW button the tape.
5. When tape comes to an end in play mode, tape will
automatically
6. Turn off the cassette by pressing the STOP/EJECT
button.