User`s manual
DVD LORD
32
VGA (only in DVD-031, DVD-032 and DVD-033)
HDMI (only in DVD-034)
USB Port
(Only in DVD-032, DVD-033 and DVD-034)
The USB port could read any USB 1.1 device, to take
the MP3 player as an example, we just plug it into the DVD
player, then the player could play the music which is stored
in the MP3 player.
Card Reader
(Only in DVD-033 and DVD-034)
The Card Reader could read such card as MMC, SD,
MS for example, SD which is used on the digital camera
could be read in the player, just plug the card into the card
reader, the player could read the JPEG pictures les in the
card, if you want to take out the card, just press the card
again, the card reader will eject it.
Troubleshooting
Check the following guide for a possible correction to
a problem before contacting customer service.
Symptoms and Correction
No power
Connect the power plug into the wall outlet securely.
Or no press ON/STANDBY/OFF button
No picture
Verify the connection from the DVD video output to
the TV video input. Then switch TV to appropriate
mode (video 1)
Connect the video cable into the jacks securely.
Refer to your television owners manual.
No sound
Connect the audio cables into the jacks securely
Verify the connection from the DVD audio output to
the TV or receiver audio input. Then switch to the ap-
propriate source on the receiver. Refer to your audio
amplier owners manual.
Black & White picture
Damaged S connector (bent pin)
The playback picture has occasional distortion
A small amount of picture distortion may appear be-
cause of a poor quality video/sound transfer to disc.
This is especially true of some discs manufactured
between 1997-1998.
Scratched disc
Brightness is unstable or noises are produced on
playback pictures
Connect the DVD player directly through the TV and
not through any other source. What you’re viewing is
the effect of the copy protection circuitry required on
all DVD players.
If you don’t have a video input on your TV, you must
purchase an RF adapter from your dealer
The DVD video player does not start playback
Place the disc with the graphics side up.
Place the disc on the disc tray correctly inside the guide
.
Make sure the disc is free from scratches & ngerprints
.
Press the SETUP button to turn off the menu screen.
Cancel the parental lock function or change the pa-
rental lock level.(The Pre-set password is 3308.)
Turn the power off then disconnect the power plug
and reinsert it back into the wall. Retry again.
The recorder Cannot record.
The type of the disc is wrong, it’s not a DVD+RW
or DVD+R disc.
The disc is recorded full.
The disc (DVD+R or DVD+RW) is locked, it should
be unlocked. The DVD+R has been nalized.
Different format (NTSC/PAL) between the disc and
the signal.