User`s manual

USER’S MANUAL
13
4. Dashboard or Console
5. Hook (Remove this part)
Note: the mounting box, outer trim ring, and half-sleeve are
not used for method B installation.
Detachable Control Panel (DCP)
Removing The Detachable Control Panel (D.C.P.).
1. Turn the power o
2. Press the D.C.P. release button
3. Remove the D.C.P.
1. Attach the panel at the right side rst, with point B on
the main unit touching point A on the D.C.P. (As shown on the
diagram).
2. Then press the left side of D.C.P. onto the main unit until a
click sound is heard.
Coution!
DO NOT insert the D.C.P from the left side. Doing so may
damage it.
The D.C.P can easily be damaged by shocks. After removing
it, place it in a protective case and be careful not to drop it or
subject it to strong shocks.
When the release button is pressed and the D.C.P is unlocked,
the car’s vibrations may cause it to fall. To prevent damage to the
D.C.P, always store it in a protective case after detaching it.
The rear connector that connects the main unit and the D.C.P
is an extremely important part. Be careful not to damage it by
pressing on it with ngernails, pens, screwdrivers, etc.
Note:
If the D.C.P is dirty, wipe o the dirt with soft, dry cloth only.
And use a cotton swab soaked in isopropyl alcohol to clean the
socket on the back of the D.C.P.
Electrical Connection
a. Make sure your car battery is a 12 volt (6 ller caps) negative
ground system (if not, a converter will be necessary).
b. Before starting wiring connections, disconnect the power
supply by removing the fuse from the fuse box.
c. Connect the power wire to one of the extra terminals of
the fuse box.
d. Connect the black ground wire to a metal part of the car. It
is important to make good contact.
e. Make other wiring connections as shown.
LOOK ON THE PANEL
f. If your car does not have ISO connector, you can procure it
from any car accessory shop.
Notes:
INCORRECT WIRING OR OPERATION WILL AVOID THE WAR-
RANTY OF THIS UNIT.
Fuse Replacement
To replace the fuse, pull out the blown fuse from the socket.
Insert a new one with same rating
General Operation
POWER ON/OFF BUTTON ( PWR )
Press POWER button or any other button on the front of the
radio to turn the unit on. Long Press POWER button again to
turn the unit o.
MUTE BUTTON
Press the mute button momentarily to mute the audio volume,
and „Mute” will ash in the display. Press the mute button again
to restore volume to the previous setting.
AUDIO BUTTON
You can operate the following function through Audio
Button.
Press AUDIO button for less than 1 second to open the Audio
menu.
Press AUDIO repeatedly to navigate through the following
functions: