Instructions / Assembly

QUICK ASSEMBLY GUIDE

Training Wheels

Folding Pedals

Handlebars &

Fork

IMPORTANT: Refer to bicycle owner’s

manual for complete installation instructions

and product warnings. Use this insert along

with the bicycle owner’s manual.

Push up until leg CLICKS into place.

Pull down on leg to ensure it is

locked securely.

Ensure Shoulder Clip

is over locking pins

before assembling.

With bike on

ground, push

down on

handlebar

assembly

until it CLICKS

into place.

Pull up on

handlebar

to ensure it

is locked

securely.

Rotate pedals

outward until they

CLICK into place.

Attempt to rotate

pedals back to ensure

they are secure.

PAGE 1
Handlebars & Fork Folding Pedals QUICK ASSEMBLY GUIDE Training Wheels Ensure Shoulder Clip is over locking pins before assembling. Rotate pedals outward until they CLICK into place. With bike on ground, push down on handlebar assembly until it CLICKS into place. Attempt to rotate pedals back to ensure they are secure. Pull up on handlebar to ensure it is locked securely. Push up until leg CLICKS into place. Pull down on leg to ensure it is locked securely.
PAGE 2
Ready 2 Roll | 2 Minute Assembly - additional information Training Wheel Instructions To adjust the training wheels, loosen the training wheel nuts circled above. Slide the wheel up or down to the correct position. Re-tighten the training wheel nuts. To remove training wheels, insert straight-slot screwdriver under the tension clip (as seen above) and pull training wheel leg straight down and out. Repeat for opposite side. WARNING - Before each ride, make sure both axle nuts are tight.