Instructions / Assembly

Ready 2 Roll | 2 Minute Assembly - additional information
To adjust the training wheels, loosen the
training wheel nuts circled above. Slide the wheel
up or down to the correct position. Re-tighten the
training wheel nuts.
Training Wheel Instructions
To remove training wheels, insert straight-slot
screwdriver under the tension clip (as seen above)
and pull training wheel leg straight down and out.
Repeat for opposite side.
WARNING - Before each ride, make sure both axle
nuts are tight. Also make sure both training wheels
are the same distance from the ground (1/8in
(3.17mm)) and securely attached.