Owner`s manual

20
figure 09. Correct RJ Cable Orientation
Step 6: Double check that the blue wire is to the right side with the tang down
and then take the RJ crimping tool in your right hand. With your left hand push the
cable with un-crimped plug into the 6-pin die on the crimping tool.
Step 7: While using your left hand to make sure that the RJ cable is firmly held all
the way into the connector, squeeze the crimping tool all the way with your right hand to
complete the crimp.
If you have a clear plug-end, you can look in and make sure that each of the 6 metal
pins sank all the way down into their respective wires. Give the connector a slight tug to
make sure that it is adequately fastened and now you have created a proper reg bus RJ
cable end.
Follow the same steps on the other end of the cable and you are done. NOTE! When
crimping the second end of the cable, notice that you’ll have to flip it over in order to
again orient the blue wire to the right when the connector tang is facing down.
(see figure 10. )