Owner`s manual

User Control Panel
The user interface panel is the long blue panel with yellow text near the top of the
charger. The only thing most users need be concerned with are the LED indicators,
the VOLTS TRIM and the adjustable AMPS knob. Below are explanations of each
feature in order from left to right. Refer to figure 02 for specific locations.
“VOLTS TRIM”
This controls the peak DC voltage ceiling that the charger will allow the batteries to
reach before limiting the current. Unless specified otherwise, the voltage limit is
specifically calibrated and set by Manzanita Micro to 191 Volts (for a 156V nominal
pack.) In the event that adjustment is desired, please follow the instructions below.
NOTICE! Always use an appropriately sized insulated screw driver when adjusting
the voltage trim potentiometer. Suitable drivers are available for purchase from
Manzanita Micro or other electronics components manufacturers. (Mouser part #:
594-8T000, Vishay/Spectrol Adjust Tool, www.mouser.com)
figure 03: Adjustment Tool # 008T000
5