User Manual

126 MAPware-7000 Programming Manual
1010-1040, Rev. 02
ii. Screen Number: screen number of the popup keypad used.
e. Ranges (for data entry objects): these are the limits allowed when entering a
new number.
i. Maximum Value (List P) - enter the maximum value that the HMC
operator can enter into the target register.
ii. Minimum Value (List P) - enter the minimum value that the HMC
operator can enter into the target register.
Q- Tag Properties:
a. Tag Address: this is the address of the target register monitored.
b. Tag Name: this is the name given to the target register in the Tag Database.
R- Tag A/B: for objects that perform a mathematical operation on two addresses (ex. Add
Tag B to Tag A) or copy from one address to another (i.e. recipes).
a. Tag A Address: Address assigned to Tag A in the Tag database.
b. Tag B Address: Address assigned to Tag B in the Tag database.
S- Design: The programming software uses this section to identify each object. For this
reason, the user cannot edit this section.
a. Id: this is an identification number assigned to the object.
b. Name: this is the name given to the object.
T- Layout: this section provides the coordinates for the selected object.
a. Bottom Right (or End Pt.): coordinates (pixel location) of the end point of the
object
b. Size: The total size (in pixels) of the selected object. The first value is the width,
and second value is height.
c. Top Left (or Start Pt.): location of the start point of the object
Refer to the above section often when working with screen objects. The next section covers all
objects that are placed onto a screen.
Simple Drawing Tools and Static Objects
The MAPware-7000 software provides many drawing tools used to create simple graphics on a
screen. Sophisticated static objects are also available to display graphics or text. Static objects
(as opposed to dynamic objects) are screen objects that do not change what displays on screen.
Dynamic objects (such as lamps or numeric input registers) change according to the value of a
coil or register in a PLC or internal memory of the HMC7000. This section provides descriptions
of the simple drawing tools and static objects available in the MAPware-7000 software.