Specifications

3024270 Rev G D 14Oct13
8.0 23G SOFTWARE 103
8.1 Calibration Procedures – Version 2 Software 103
8.2 pH Calibration Procedure – Software Version V2 104
8.3 V2 Logic Board 105
8.4 Temperature Calibration Procedure – V2 108
8.4.1 Cleaning the Feed Conductivity Sensor 108
8.4.2 Calibrating the Temperature 108
8.5 Conductivity Calibration Procedure – V2 109
8.5.1 Measuring the Conductivity of Feed and Permeate Samples 109
8.5.2 Verifying the Percent Rejection Reading on the ECM-100 109
8.5.3 Displaying the Feed Conductivity on the ECM-100 110
8.5.4 Calibrating the Feed Conductivity 110
8.5.5 Restoring the Rejection Low Alarm Setting 111
8.5.6 Calibrating the Permeate Conductivity 111
8.6 Pressure Transducer Calibration Procedure – V2 113
8.7 Flow Calibration Procedure – V2 114
8.7.1 Calculating Permeate Flow Rate 114
8.7.2 Calculating Concentrate Flow Rate 115
8.7.3 Calibrating the Concentrate and Permeate Flow Rate Offsets 116
8.7.4 Verifying the Concentrate and Permeate Flow Rate Slopes 117
8.7.5 Calibrating the Concentrate and Permeate Flow Rate Slopes 118
9.0 RETURNED MATERIAL AUTHORIZATION PROCEDURE 121
10.0 SERVICE ASSISTANCE 121
11.0 SPARE PARTS LISTS 122
Valves 122
Prefilters 122
6-Channel Remote 122
Flow Block and Connectors 122
Sensor 123
Electrical 124
Membrane Elements 124
4-inch Housing Spare Parts 124
Test Kits 125
Clamps 125
Miscellaneous 125
Pump Outlet 125
Pump and Motor Assemblies (Three-phase, 60 Hz) 126
Pump and Motor Assemblies (Three-phase, 50 Hz) 127
Pump and Motor Assemblies (Single-phase) 127