Operator`s manual

P/N 3027435 Rev. C

Regular Maintenance

WRO 300

Step 7 From CHEM SELECT, press to enter the list of available

Cleaning and chemical disinfection programs.

Step 8 Select preferred chemical disinfection program by using the

arrow buttons.

Step 9 Initiate the disinfectant intake by pressing until light goes

on.

The table below explains how to pause, interrupt or restart the proce-

dure.

Step 10 401 REMOVE WAND is displayed and the buzzer sounds and

is flashing, press .

NOTE

The display shows present phase of the chemical disinfection proce-

dure.

NOTE

The container can be empty before the intake phase is finished.

CAUTION

The chemical disinfection has to be restarted if alarm 406

INSUFFICIENT INTAKE has appeared.

Action

Pause of chemical

intake phase

Press until light flashes. To continue the intake

press again until light goes on.

Interrupt chemical

disinfection procedure

Disconnect the wand connector and press until

light goes on, to initiate rinse.

Restart of intake phase

Remove the wand connector and insert it again CHEM

INTAKE RESTART appears on the display and

flashes. Then press until light goes on.

MINNCARE

CHEM INTAKE

μS