Operator`s manual

WRO 300 H

P/N 3027436 Rev. C

Introduction

1 Introduction

1.1 Intended Use

The MCP WRO 300 H Water Purification Unit is intended to be used

as a dialysis accessory to produce water through reverse osmosis for

one hemodialysis equipment.

The WRO 300 H can be connected to hemodialysis equipment used

both in hospitals and in home environments, in conjunction with appro-

priate pre and post treatment units, as a part of a water treatment sys-

tem designed to meet applicable regulations or standards for water for

dialysis, for example current AAMI and Federal (U.S.) standards.

1.2 General

The WRO 300 H has been designed to fulfil the special requirements

within a dialysis setting. This device has the following features:

• Simple user interface

• Automated heat disinfection

• Chemical disinfection and cleaning modes

• Auto flush function during standby periods to minimize stagnant

water.

This manual for WRO 300 H includes instructions for operating, moni-

toring, cleaning, disinfecting and troubleshooting this device from an

operator’s perspective. For installation instructions refer to separate

Installation Guide.

CAUTION

The water produced by WRO 300 H should be analysed at

installation and on a regular basis to verify that it conforms to

applicable regulations or standards for water for dialysis.