User's Manual

ManualsBrandsMarantec America ManualsElectronicsRemote Control Transmitter

Table Of Contents

4. Multiple Transmitters (Figure 3)

Each transmitter comes factory programmed with random

codes. 2-channel transmitters have 2 different random codes,

one per button, 3-channel transmitters have 3 different random

codes and 4-channel transmitters have 4 different random

codes, one per button. Transmitters that are purchased

separately as accessories have random codes that must be

changed in order to match the code of the "active" transmitter,

which you are alredy using. Below are instructions for

transferring an active code from a button on one transmitter to a

button of your choice on another transmitter.

Connect the transmitter with active code to the new

transmitter using the programming connector (fig. 3A).

Press and hold the selected channel button on the transmitter

with the active code (fig. 3B). The light in the transmitter

illuminates.

Press and hold the respective channel button on the new

transmitter (fig. 3C). The light in the transmitter initially starts

blinking and then illuminates continuously after 1-2 sec. Code

transfer is completed.

Programming conn ector can be removed and both transmitters

can now be used to operate the same door.

Note: For multi-button transmitters, be sure to carry out this

procedure for all the buttons you desire to use.

5. Changing the Code on Transmitters (Figure 4)

The transmitter factory preset code can be changes as follows:

Connect the programming connector into the lateral socket of

the transmitter to change the code.

Short one of the outer pins of the programming connector with

the middle pin.

Press and hold the respective channel button. The light will blink

rapidly for approx. 5 sec. Release the button after the light

illuminates continuously. Then remove the programming

connector.

Note: For multi-button transmitters, be sure to carry out this

procedure for all the buttons you desire to use.

Figure 3. Multiple Transmitters-Code Transfer

Transmitter with active Code

new Transmitter

Programming

Connector

fig. 3A

fig. 3B

fig. 3C

Figure 4. Code Changing

FCC Certified: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user´s authority to operate the equipment.

Transmitters

Instructions

(continued)