Instructions / Assembly

24
Fig. 53
14. OPERATION OF YOUR OPERATOR (cont’d)
Fig. 52
Lock/Vacation Button
Light On/Off Button
Illuminated Door Pushbutton
15. HOMELINK
®
TRANSCEIVER
REMOTE CONTROL TRANSMITTER:
 To open or close garage door, press and hold designated button
(Transmitter has an indicator light that will illuminate). See Fig. 51.
When garage door begins to move, release button.
 To stop garage door during travel, press and hold button until
door stops, then release button.
 To resume garage door travel after stopping, press button
again. Door begins to move in the opposite direction.
Before you can use your car’s HomeLink
®
device to open a
garage door you must transfer an active code from the
transmitter to the HomeLink
®
Universal transceiver.
(Reference - HomeLink
®
Manual) (See Fig. 53)
Clear memory in HomeLink® transceiver per manufacturer
instructions.
Make sure the door path is clear and the door is in the line
of site at all time during the set up.
Start the programming sequence by pressing the
transmitter button and the HomeLink® transceiver button
on console simultaneously. Follow manufacturer
instructions to complete programing sequence. No learn
button on the operator is required to be pressed.
Repeat steps above for the other channels available.
WALL CONTROL PANEL:
 The Door Pushbutton will light when Wall Control properly
connected (if it does not light up, review section 8-13
“Install Wall Control” on page 15.
To open or close garage door, press and hold Illuminated Door
Pushbutton. See Fig. 52. When garage door begins to move,
release button.
To stop garage door during travel, press and hold button until
door stops, then release button.
To resume garage door travel after stopping it, press button
again. Door begins to move in the opposite direction.
 The Light On / Off button can be used to turn lights on or off.
When using the light On / Off button, the automatic timer is
ignored, and the lights will remain on until the button is pressed
again, or until the operator is activated and the automatic timer
begins again.
 The Lock/Vacation button can be used to lock out all remote control
transmitters. The door can still be activated by wall control panel or
keyless entry system. Press and hold Lock/Vacation button for 2-3
seconds. Release button. Illuminated Door Pushbutton will flash
continuously while lock mode is active. To unlock opener, press and
hold Lock/Vacation button for 2-3 seconds.
OPERATOR LIGHT:
 Light will come on whenever operator is activated.
The default factory setting for the light to stay “on” is 4
minutes and 15 sec., or until the Light On / Off button on the
wall control panel is pressed, whichever is sooner.
 Light can be turned on and off manually as described under
operation of wall control panel.
 Light will flash when the operator senses an obstruction either
detected by the internal safety system or the photo eye sensors.
To stop light from flashing, remove obstruction and operate
door normally. The fault light indicator will flash for the set
light time “on” factory default setting of 4 minutes
15 sec. maximum.
Important Note: If the vacation lock
mode is engaged.
By pressing and holding the door
activation button for one second or
longer will disengaged the vacation lock
mode.
Fig. 51
Indicator Light
Buttons
NOTE: The operator light will dim down when
turned off.




Operating the door using a hand transmitter
1.
The control system is in
operating mode.
2.
Impulse
Impulse
The door moves in the
OPEN direction
3.
The operator system stops.
4.
The door moves in the opposite
direction (CLOSE direction).
Impulse
NOTE: For additional light installation refer to page 29.