Instructions / Assembly

19
11. SYSTEM SET UP (cont’d)
System initial
display on
control panel
screen upon
power ON
Control Panel
Display
1
2
3
System display
on control panel
screen after set-
up is completed.
System set up start and program open door travel position
P
Program close door travel position
Program a remote control (transmitter)
To start the system set up, press and hold the button for approximately
5 seconds.

The blinking closed door icon is displayed on the control panel screen.
The transmission icon will blink on the control panel display.
This indicates the operator is ready to learn the remote control code.

Press and hold the button on the remote control that you wish to use.
The transmission icon will change its displayed symbol to a solid icon.
This indicates that the remote control code has been successfully learned by operator.

Press button to save remote control code and end the system set up.
Release the remote control button. 
Once the desired close travel position is reached press button to save
the close travel position and move to the next step in the system set up.

Set the close door travel position by pressing and holding the button
until the door reaches the down travel postion desired.
Important Note: In order to avoid unintentional door reversal, DO NOT
set the down travel position too close to the floor where the door
rubber seal is completely squeezed/compressed against the ground.
Further fine tuning of the close travel position can be performed by using the
or buttons.

Once the display timer counter reaches the count of 5, release the
button.

P
The blinking open door icon is displayed on the control panel screen.
Once the desired open travel position is reached, press button to save
open travel position and move to the next step in the system set up.

Set the open door travel postion by pressing and holding the
button until the door reaches the desired open travel position.
Further fine tuning of the open position can be performed by using the
or buttons.

P
P
P
Legend:
NORMAL OPERATION
IMPORTANT:
On the first open travel activation, the trolley will make
contact with and will rest against the rail bumper.
This will appear as if the system (door) went past the
set open travel limit. However, this is not the case.
On the next open travel cycle, the system will
recognize the program travel limit.
Every 20 cycles the operator will perform a travel limit
check and it will function as described on
“Normal Operation” note.
Drive the door in the OPEN direction, increase the value
Drive the door in the CLOSE direction, decrease the value
Start programming, comfirm and save values
The display flashes
Display lights up
Ready for operation
Door position: CLOSED
Door position: OPEN
Photoeye safety system or closing edge safety device
Remote control
External button
Fault message/Maintenance indicator in CLOSED door position
P
Important Note: The back of the trolley must be approximately
half inch from the reference bumper on rail.