Instructions / Assembly

20
IMPORTANT:
Upon completion of the initial set up, the
operator must be cycled for two complete
cycles (complete cycle comprises of one
uninterrupted up activation of the system
and one uninterrupted down activation
of the system).
12. OPERATOR RESET
1.
Door should be in closed position.
The control system operating mode
will be displayed as shown.
2.
P
Press and hold button until
counter passes number “10”.
Then release the button.
1
2
3
4
5
6
7
8
9
0
3.
Press to select Level 1.
Screen display as shown.
Screen display as shown.
1
2
3
4
5
6
7
8
9
0
4.
Press . Menu 3 will appear on
display as shown.
Press and release .
Number “1” blinks.
1
2
3
4
5
6
7
8
9
5.
Press to select Menu 8
(reset menu).
Screen will display “1” as shown.
1
2
3
4
5
6
7
8
9
0
6.
1
2
3
4
5
6
7
8
9
0
7.
Press and release to change
screen display.
Number “2” will blink.
8.
Press and release to reset operator.
9.
10.
During reset the display screen will turn
blank for a couple of seconds.
Upon completion of operator reset,
the LCD display illuminates.
Stand-by mode is displayed
as shown.
The operator must be set-up again as
described in Section 11.
Reset Procedure
1/2
1
P
P
P
P
There might be times when the operator may have to be reset in order
to restore the operating system factory default setting.
1
2
3
4
5
6
7
8
9
0