Instructions / Assembly

22
Fig. 45
Fig. 46
Coin
Battery
Progamming Buttons
LED (Indicator Lights)
CHANGING THE CODE (Fig. 45):
The transmitter factory preset code can be changed as follows:
 Insert the programming connector into transmitter terminal.
 Short one of the outer pins of the programming connector
with the middle pin.
 Press and hold the respective channel button. The light will
blink rapidly for approximately 5 sec. Release the button after
the light illuminates continuously. Code will change in
approximately 2 seconds.
 Remove the programming connector.
 Once the transmitter code is changed, the operator must be
recoded with the new transmitter code as described on the
initial system set up page 19.
NOTE: For multi-button transmitters, be sure to carry out this
procedure for all the buttons you desire to use.
BATTERY REPLACEMENT (Fig. 46):
 Open the transmitter by using small coin.
 Insert a 3V battery (type CR2032) as shown.
 Close the transmitter.
NOTE: Replace batteries with same type only.
13-1. TRANSMITTER (cont’d)
13-2. WIRELESS KEYLESS ENTRY SYSTEM
•
•
•
•
To prevent possible SERIOUS INJURY or DEATH from a moving
garage door:
Install Wireless Keyless Entry System within sight of the garage
door, out of reach of children at a minimum height of 5 feet (1.5m)
and away from ALL moving parts of the door.
ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote controls.
Activate door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
ALWAYS keep garage door in sight until completely closed.
NEVER permit anyone to cross path of moving door.
PROGRAM PIN AND TRANSFER CODE
 Installl batteries provided in WKE, Fig. 50.
 Press and hold button for at least 3 seconds to activate
programming mode, LED’s light up for 10 seconds.
 Immediately, aim the top of transmitter very close to buttons
and .
Press and hold button you use to operate the door and move
transmitter slowly down toward the number and button area.
Release transmitter button when LED’s on keypad flash.
 Immediately, enter a 4-digit personal identification number (PIN)
of your choice # # # #.
 Immediately, press and release the ENTER button. LED’s and keypad
buttons will light up for 2 seconds signaling programming is completed.
 Test WKE by entering the PIN, then press ENTER button.
NOTE: To program the WKE to more than one garage door
operator (maximum 4), repeat the steps above using a new
PIN for each additional garage door operator.
Fig. 48
Fig. 47
The Wireless Keyless Entry System offers you the convenience of opening and closing your garage door by entering your own 4-digit
Personal Identification Number (PIN) via the keypad. The WKE can be programmed wireless to control up to 4 garage door operators that
each work on a different code, or to control one garage door operator with up to 4 different PINs. You can also program it to allow a
temporary PIN of your choice to be stored, to provide temporary access to authorized visitors or service persons.
ENTER Button