User guide

10
ENGLISH
NAMES AND FUNCTIONS BASIC CONNECTIONS BASIC OPERATIONS
ADVANCED CONNECTIONS
ADVANCED OPERATIONS TROUBLESHOOTING OTHERS
BASIC CONNECTIONS BASIC OPERATIONS
BASIC CONNECTIONS
7
Wiring speaker cable
1.
Strip away approx. 10 mm (3/8 inch) of wire insulation.
10 mm
(3/8 in)
2.
Twist the bared wire ends tight, to prevent short circuits.
3.
Loosen the knob by turning it counterclockwise.
4.
Insert the bare part of the wire into the hole in side of
each terminal.
5.
Tighten the knob by turning it clockwise to secure the
wire.
CONNECTING OF AC POWER CABLE
1.
Plug the supplied AC power cable to the AC IN socket on
the rear panel of the main unit.
AC IN
2.
Plug the power cable into an AC outlet.
AMP OPERATION
7
Turning the Unit ON
POWER ON/OFF button
1.
Turn on the connected audio equipment, such as a CD
player.
2.
Press the POWER ON/OFF button of this unit.
7
Input Source Selection
Example: CD playback
(Operation with the controls on the main unit)
Set to CD by turning the INPUT SELECTOR knob.
(Operation with the controls on the remote controller)
Press the CD button on the remote controller.
L
TRIM
CLOSE MODE
PHONO CD BALANCED
RECORDER 1 LINE 1
RECORDER 2 LINE 2
EXIT TONE
ENTER
+
OPEN/ SOUND
R
INPUT SELECTOR knob
CD button
To use the speakers connected to the SPEAKER SYSTEMS
terminals, press the SPEAKERS button on the front panel to
set it to ON.
BASIC OPERATIONS
PM-15S2_UN_01_Eng.indd 10 09.5.18 2:57:00 PM