Owner's Manual
Table Of Contents
- Quick Start Guide
- Owners Manual
- Reset
- Panel Lock
- Remote Lock Function
- Video Conversion Function
- Features
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Connections
- Troubleshooting
- Specs
- Index
- Spec Sheet
- Microphone Stand Assembly Instructions
- Scan of CD-ROM
- Speaker Wire Labels
- Warranty
o
Experimenting with preset codes one by one
for registration
1
Switch the power on of the device for which you want
to set the preset code.
2
Press and hold down the input source select button
that you want to register the preset code to and SET
until “PRSET” indicator on the remote control display
is flashing, then release.
3
Aim the remote control at the appliance and slowly
alternate between pressing CH/PAGE d and DEVICE X
for the appliance.
The preset code is shown in the remote control display.
4
Stop when the appliance turns off.
5
Press ENTER once to lock in the code.
0
Some manufacturers use more than one type of remote control code. Preset
codes to change the number and verify correct operation.
0
If the AV device is not a Marantz device, or if the device does not operate even
when the preset code is registered, use the learning function. Remote codes for
different devices can be remembered for use by the Marantz remote control
included with this device. (v p. 325)
NOTE
Depending on the model and year of manufacture of your device, some buttons may
not operate.
Contents Connections Playback Settings Tips Appendix
255
Front panel Display Rear panel Remote Index