Operation Manual

98
1
Set up the zone mode
Press ZONE SELECT to switch “MAIN”.
Press ZONE SELECT
NOTE
When using a remote control with preset codes registered
(vpage 154), press AVP to set the remote control to the AVP-
operation mode before operation.
2
Connect the setup microphone.
Audyssey Setup
Channel Select
Start
Your AV preamp can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
When the setup microphone is
connected, the following screen is
displayed.
Set up speakers
around items indicate the settings.
This section describes detailed settings for Audyssey
®
Setup.
Connecting the Pre Tuner, Power Amplifier and your TV.
Before Audyssey
®
Setup measurement, the settings shown below can be made.
•Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage98
“Set up “Channel Select””).
n Audio output from each PRE OUT terminal
PRE OUT channel
UNBALANCED RCA PRE OUT terminal FL/FR C SW1/SW2 SL/SR SBL/SBR FHL/FHR FWL/FWR
BALANCED XLR PRE OUT terminal FL/FR C SW1/SW2 SL/SR SBL/SBR FHL/FHR FWL/FWR
Audio Output Front Center
Subwoofer 1 /
Subwoofer 2
Surround Surround Back Front Height Front Wide
3
Set up “Channel Select”
Use ui to select “Channel Select”, and then press
ENTER.
Channel Select
Subwoofer
Surround Back
Front Height
Measure(1spkr)
Measure(2spkrs)
Measure
Front Wide Measure
Audyssey Setup
Channel Select
Start
Your AV preamp can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Basic version
Advanced version
Informations
Advanced version
v See overleaf
DVD