Owners Manual

During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.

This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos signal is played.

This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS:X or DTS signal is played.

This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input.

This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.

This item can be selected when Height, Ceiling or Dolby Atmos Enabled speakers are used.

z7 This setting is available when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v

p. 229)

z8 This item can be set when “Front” is set to “Small” or “Subwoofer Mode” is set to “LFE+Main”. (v p. 220, 229)

This can be set if the input signal does not contain an Auro-3D signal or if the input Auro-3D signal does not contain Front Height channels.

z10 This item cannot be set when “Dynamic EQ” is set to “On”. (v

p. 178)

z11 This item cannot be set when “Subwoofer” in the menu is set to “None”. (v p. 220)

z12

This item cannot be set when Audyssey

Setup (Speaker Calibration) has not been performed.

z13

This item cannot be selected when a DTS:X format with a sampling frequency of over 48 kHz is input.

z14

This item cannot be set when “MultEQ

XT32” in the menu is set to “Off”. (v

p. 177)

z15

This item cannot be set when sound mode is “DTS Virtual:X” or sound mode that have “+Virtual:X” in the sound mode name.

z16

This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.

z17

This can be set when the LFE signal is included in the input signal.

Contents

Connections Playback Settings Tips Appendix

304

Front panel Display Rear panel Remote Index