User Manual

1
Press and hold down the input source select button
that you want to register the preset code to and SET
until “PRSET” indicator on the remote control display
is flashing, then release.
2
Enter the preset number (4 digits) listed for the device
in the Preset Code Table using the number buttons (0 –
9) on the remote control.
0
Some manufacturers use more than one type of preset code. Preset codes to
change the number and verify correct operation.
0
If the device does not operate even when the preset code is registered, use the
learning function. Remote codes for different devices can be remembered for use
by the Marantz remote control included with this device. (v
p. 272)
NOTE
0
Depending on the model and year of manufacture of your device, some buttons
may not operate.
o
Experimenting with preset codes one by one
for registration
1
Switch the power on of the device for which you want
to set the preset code.
2
Press and hold down the input source select button
that you want to register the preset code to and SET
until “PRSET” indicator on the remote control display
is flashing, then release.
3
Aim the remote control at the appliance and slowly
alternate between pressing CH/PAGE d and DEVICE X
for the appliance.
The preset code is shown in the remote control display.
4
Stop when the appliance turns off.
5
Press ENTER once to lock in the code.
Contents Connections Playback Settings Tips Appendix
266
Front panel Display Rear panel Remote Index