Owner's Manual

Settings AUDIO OUT connectors
Height
Sp
Dolby Sp NOTE Front Layout
Middle
Layout
Rear Layout HEIGHT 1 HEIGHT 2 HEIGHT 3
HEIGHT 4/
FRONT WIDE
8ch None
z5
Front Height &
Center Height
Top Middle &
Top Surround
Rear Height Front Height Rear Height Top Middle
L: Top
Surround
R: Center
Height
6ch 2ch
z5
Front Height &
Center Height
Surr. Dolby &
Top Surround
Rear Height Front Height Rear Height
Surround
Dolby
L: Top
Surround
R: Center
Height
z1
This can be selected when using Surround Back speakers.
z2
For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup
in place of Surround Height speakers.
z3
Use 2 sets of Height speakers in the appropriate sound modes for Dolby Atmos, DTS:X or Auro-3D playback.
Use the Front Height and Rear Height speakers for Dolby Atmos or DTS:X playback.
Use the Front Height and Surround Height speakers for Auro-3D playback.
z4 This can be set when “Floor” - “Layout” is set to “5ch” or “5ch & SB”. (v
p. 223)
z5
This combination cannot be selected when Front Wide speakers are being used.
o
View Terminal Config.
This shows how to connect the PRE OUT connectors for your “Amp
Assign” setting on the menu screen.
Contents Connections Playback Settings Tips Appendix
229
Front panel Display Rear panel Remote Index