Operation Manual

58
TipsSettingsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Appendix
Cautions on using media
Inserting a disc
• Set the disc in the tray label side up.
• Make sure the disc tray is fully open when inserting the disc.
• Place the discs flatly, 5 inch/12 cm discs in the outer tray guide
(Figure 1), 3 inch/8 cm discs in the inner tray guide (Figure 2).
Figure 1 Figure 2
Outer tray guide
5 inch/12 cm disc
Inner tray guide
3 inch/8 cm disc
• Place 8 cm discs in the inner tray guide without using an adapter.
%
• “00Tr 00:00” is displayed if a disc that cannot be played is loaded.
• “No Disc” is displayed if the disc is loaded upside-down or if no disc is loaded.
NOTE
• Only load one disc at a time. Loading two or more discs can damage the unit or
scratch the discs.
• Do not use cracked or warped discs or discs that have been repaired with adhesive,
etc.
• Do not use discs on which the sticky part of cellophane tape or labels is exposed or
on which there are traces of where labels have been removed. Such discs can get
caught inside the player and damage it.
• Do not use discs in special shapes, as they may damage the player.
• Do not push the disc tray in by hand when the power is o.
Doing so could damage the set.