Quick Start Guide

10
Network connections and settings
n Disconnecting the iOS device
1
Press X POWER to set the
standby mode.
2
Remove the iOS device from the Dock of this unit.
NOTE
Note that marantz will accept no responsibility whatsoever for any
problems arising with the data on an iOS device when using this unit
in conjunction with the iOS device.
Wired LAN
NETLINKWPS
NETWORK
L
R
LINE IN
WIRELESS LAN
ON/STANDBY
Internet
To WAN side
Router
To LAN port
To LAN port
LAN port/
Ethernet
connector
LAN port/
Ethernet
connector
PC
NAS
(Network Attached
Storage)
Modem
Ethernet cable
(Supplied)
For connections to the Internet, contact an ISP (Internet
Service Provider) or a computer shop.
n When “DHCP” is set to “On” on your router
When using this unit with the broadband router’s DHCP function
enabled, this unit automatically performs the IP address setting
and other settings.
1
Connect the supplied Ethernet cable by referring to
the above gure.
2
Press X POWER to turn on power to the main unit.
•When this unit could not connect to the network, perform steps 1
and 2 again.
You may need to set the network connection manually, depending on
the provider you use. To set the connection manually, use the setting
procedure of “When “DHCP” is set to “Off” on your router”.
n When “DHCP” is set to “Off” on your router
Make settings by referring to “Using PC to make network settings
of this unit” (vpage11) in “When “DHCP” is set to “Off” on
your router” (vpage11) and change to the wired connection.
Preparations
Operations
Informations
Preparations