Quick Start Guide

11
Network connections and settings
Using PC to make network settings of this
unit
n When “DHCP” is set to “On” on your router
When using this unit with the broadband router’s DHCP function
enabled, this unit automatically performs the IP address setting
and other settings.
Before turning this unit on, make sure that an Ethernet cable is not
connected to this unit. If a cable is connected, have this unit enter
the power standby mode and disconnect the cable.
1
Press X POWER to turn on power to the main unit.
It takes approximately 30 seconds for this unit to start.
2
Press NETLINK on the rear panel.
This unit restarts and “NetLink” appears on the display.
3
Connect to “Consolette_Setup” in the wireless
network settings on your PC.
•If “Consolette_Setup” is not displayed, refresh the network.
•It may take up to two minutes to establish the connection.
4
Launch the browser on the PC connected to this unit,
and enter the address “http://169.254.1.1”.
5
On the page that appears, set the information
necessary for the network connection.
q Click “Profile Configuration” on the upper left part of the
page.
w From the “Digital Media Player Wireless LAN Settings”
dropdown list, select the SSID (Service Set ID) of your
router.
e Enter the password.
r When settings are completed, click “Apply”.
•“Connecting” is displayed, and the unit starts connecting to the
LAN.
•When the connection is made successfully, “Succeeded” appears.
•If the connection cannot be established, “Failed” is displayed.
Perform steps 1 – 5 again.
•It may take 120 seconds to establish the network connection.
•Enter the name in the “Digital Media Player Name” box and click
“Set” to change the friendly name. A friendly name is the name of
this unit that is presented to the network.
•In “ADVANCE SETTING”, you can manually make settings such as
the IP address.
NOTE
When using PC to make settings, disable the proxy setting in your
browser.
n When “DHCP” is set to “Off” on your router
This section explains the settings when connecting this unit to a
network that does not have a DHCP function.
To configure the settings manually, check the setting details with
your network administrator.
1
Complete steps 1 – 4 in “Using PC to make network
settings of this unit” (vpage 11).
2
On the page that appears, set the information
necessary for the network connection.
q Click “Profile Configuration” on the upper left part of the
page.
w Click “ADVANCE SETTING”.
e Enter required items.
r When settings are completed, click “Apply”.
•“Connecting” is displayed, and the unit starts connecting to the
LAN.
•When the connection is made successfully, “Succeeded” appears.
•If the connection cannot be established, “Failed” is displayed. Turn
this unit off and on.
If this unit is still not connected to the network after this procedure,
complete steps 1 – 2 again.
Preparations
Operations
Informations
Preparations