Quick Start Guide

26
Auto Standby
With the Auto Standby ON, this unit will automatically enter the
standby mode after about 30 continuous minutes of stop mode with
no operation.
•The default setting for the Auto Standby mode is “Off”.
1
Press FUNCTION repeatedly until
“Menu” is displayed.
“Menu” is displayed, then “Language”
menu appears.
ELECTRONIC GYRO TOUCH
ENTER
FUNCTION
PLAY/PAUSE
2
Turn GYRO to select “Auto-
Standby”, then press ENTER.
ELECTRONIC GYRO TOUCH
ENTER
FUNCTION
PLAY/PAUSE
Auto-Standby
3
Turn GYRO to select the item you want to check, then
press ENTER.
On
(Auto Satandby On)
The unit goes into standby after 30 minutes.
Off
(Auto Satandby Off)
The unit does not go into standby automatically.
You can also switch the power to standby by pressing ON/STANDBY
on the main unit.
NOTE
In the following situations, the Auto standby function does not operate.
•When iPod, iPhone or iPad is connected to the Dock connector on
this unit.
•When the input source is “LINE IN”.
•When the input source being played is “Internet Radio”or “Music
Server”.
n Exiting the menu to return to the normal mode
Press FUNCTION.
•If you press FUNCTION before pressing ENTER, the setting is
cancelled.
WPS Settings (PIN code method)
Use this procedure to configure the wireless LAN settings.
Before turning this unit on, make sure that an Ethernet cable is not
connected to this unit. If a cable is connected, have this unit enter the
power standby mode and disconnect the cable.
1
Press FUNCTION repeatedly until
“Menu” is displayed.
“Menu” is displayed, then “Language”
menu appears.
ELECTRONIC GYRO TOUCH
ENTER
FUNCTION
PLAY/PAUSE
2
Turn GYRO to select “WPS(PIN)”,
then press ENTER.
ELECTRONIC GYRO TOUCH
ENTER
FUNCTION
PLAY/PAUSE
WPS(PIN)
•“Searching” is displayed, and the access point you have set is
displayed.
3
Turn GYRO to select the access point whose PIN code
you want to display, and press ENTER.
PIN code number is displayed.
4
Set this PIN code to the register.
•For how to register the PIN code, see the owner’s manual of your
router with access point.
•When connection is established with access point, “Succeeded”
is displayed.
n Exiting the menu to return to the normal mode
Press FUNCTION.
•The unit exits the setting mode and the normal display returns.
To return to the top of menu, turn GYRO to select “Exit”, then press
ENTER.
Setting the network (Network Info.)
Checking the network information
1
Press FUNCTION repeatedly until
“Menu” is displayed.
“Menu” is displayed, then “Language”
menu appears.
ELECTRONIC GYRO TOUCH
ENTER
FUNCTION
PLAY/PAUSE
2
Turn GYRO to select “Network
Info.”, then press ENTER.
ELECTRONIC GYRO TOUCH
ENTER
FUNCTION
PLAY/PAUSE
Network Info.
3
Turn GYRO to select the item you want to check, then
press ENTER.
n Exiting the menu to return to the normal mode
Press FUNCTION.
•The unit exits the setting mode and the normal display returns.
To return to the top of menu, turn GYRO to select “Exit”, then press
ENTER.
Preparations
Operations
Informations
Operations