Operation Manual

Wireless LAN
.
Internet
Modem
To WAN side
Router with access point
0
With this unit, it is possible to use the DHCP and Auto IP functions to make the
network settings automatically.
0
When using this unit with the broadband router’s DHCP function enabled, this unit
automatically performs the IP address setting and other settings. When using this
unit connected to a network with no DHCP function, make the settings for the IP
address, etc., at “Network”. (v
p. 84)
0
When using this unit, we recommend you use a router equipped with the following
functions:
0
Built-in DHCP server
This function automatically assigns IP addresses on the LAN.
0
Built-in 100BASE-TX switch
When connecting multiple devices, we recommend a switching hub with a
speed of 100 Mbps or greater.
0
Use only a shielded STP or ScTP LAN cable which is easily available at
electronics stores. (CAT-5 or greater recommended)
0
The normal shielded-type LAN cable is recommended. If a flat-type cable or
unshielded-type cable is used, other devices could be affected by noise.
0
When using a WPS (Wi-Fi Protected Setup) compatible router, you can connect
easily to Wi-Fi by pressing the Wi-Fi CONNECT button (WPS) on this unit. (See
the separate “Quick Setup Guide”.)
Contents
Connections Playback Settings Tips Appendix
25
Front/Top
panel
Rear panel
Remote control
unit
Index