Operation Manual

Appendix

TipsSettingsPlayback

Contents

Front panel Rear panel IndexRemote

Connections

Speaker connection

Here we connect the speakers in the room to this unit.

This section explains how to connect them using typical examples.

NOTE

•Disconnect this unit’s power plug from the power outlet before connecting the

speakers. Also, turn o the subwoofer.

•Connect so that the speaker cable core wires do not protrude from the speaker

terminal. The protection circuit may be activated if the core wires touch the rear

panel or if the + and – sides touch each other (vpage115 “Protection circuit”).

•Never touch the speaker terminals while the power cord is connected. Doing so

could result in electric shock.

•Use speakers with an impedance of 6 – 8 Ω/ohms. The protection circuit may be

activated if speakers with an impedance other than speciﬁed are used.

Connecting the speaker cables

Carefully check the left (L) and right (R) channels and + (red) and – (black)

polarities on the speakers being connected to this unit, and be sure to

connect the channels and polarities correctly.

Peel o about 10 mm of sheathing from

the tip of the speaker cable, then either

twist the core wire tightly or terminate it.

Turn the speaker terminal counterclockwise

to loosen it.

Insert the speaker cable’s core wire to the

hilt into the speaker terminal.

Turn the speaker terminal clockwise to

tighten it.