Operation Manual

126
Appendix
Tips
Settings
Connections
Contents
Front panel Display Rear panel IndexRemote
Playback
Remote lock function
When connecting an IR receiver, enable the Remote lock function. When
the function is enabled, you can not perform operations with the remote
control unit.
By default, this function is disabled.
X
M-DAX STAT U S
DISPLAYPRESET CH +
PRESET CH –
Disabling the sensor function of the
remote control unit
1
When the main unit is in standby mode, press X while
holding down DISPLAY and M-DAX on the main unit.
2
Press PRESET CH + or PRESET CH – to select “RC LOCK
On”.
3
Press STATUS to enter the setting.
The infrared light receiving function is disabled.
Enabling the remote sensor function
1
When the main unit is in standby mode, press X while
holding down DISPLAY and M-DAX on the main unit.
2
Press PRESET CH + or PRESET CH – to select “RC LOCK
zO”.
(z The currently set mode.)
3
Press STATUS to enter the setting.
The infrared light receiving function on the main unit is enabled.