User guide

18
ENGLISH
iPod
®
playback
With this unit, you can listen to music on an iPod. It is also possible to
operate the iPod from the main unit or remote control.
For the supported iPod models, see “Connecting an iPod” (vpage8).
n iPod
®
(vpage40)
Before playing a USB or an iPod
1
Press ON/STANDBY.
2
Connect USB memory device or iPod connection
cable.
When the USB memory device or iPod is connected to the USB
port on this unit, the input source automatically switches to
“iPod/USB” and fi le playback begins.
NOTE
This function is activated around 1 or 2 minutes after the power is
turned on.
Playing an iPod
1
Press [MODE] to select the display mode.
The mode switches each time the button is pressed.
• There are two modes for displaying the contents recorded on the
iPod.
Remote mode
Display iPod information on the display of this unit.
Direct mode
Display iPod information on the iPod screen.
• “Direct iPod” is displayed on the display of this unit.
[Selectable mode]
Remote mode Direct mode
Display location Main unit display iPod display
Playable
fi les
Audio fi le
3 3
Video fi le
3
Active
buttons
Remote control
and main unit
3 3
iPod
®
3
The default display mode setting is “Direct mode”.
2
Use ui to select the item, then press [ENTER/
MEMO]
or <ENTER> to select the music fi le to be
played.
3
Press 1/3.
Playback starts.
Button located on both the main unit and the remote control
BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control [BUTTON]
Symbols used to indicate buttons in this guide
u
p
[ENTER/MEMO]
i
[SEARCH]
[6]
[7]
[MODE]
8
9
2
ON/STANDBY
13
[RANDOM]
[REPEAT]
o
[DISPLAY]
[HOME]
ON/STANDBY
<ENTER> u / i 8 、 92
o/p
13
Switching the reception information for the
currently tuned in DAB station
1
Perform steps 1 to 2 under “Tuning in DAB stations”
to tune in a DAB station.
2
Press [DISPLAY].
• The display switches as shown below each time the button
is pressed.
q Dynamic Label Segment :
Text data included in the broadcast is scrolled.
w Station Name :
The service station name is displayed.
e Program Type :
The category of the tuned in station is displayed.
r Ensemble Name :
The ensemble name is displayed.
t Frequency:
The frequency is displayed.
y Signal Quality :
The reception signal sensitivity is displayed (0 to 100).
• If the reception signal sensitivity is 80 or greater, the
program can be received without noise.
u Audio Information :
The mode of the currently tuned in station and its bit rate
are displayed.
Listening to DAB/DAB+
1.M-CR603N_ENG_0728.indd 181.M-CR603N_ENG_0728.indd 18 2010/07/29 20:39:222010/07/29 20:39:22