User guide

30
ENGLISH
Setting the network [Network]
When using this unit with the broadband router’s DHCP function
enabled, this unit automatically performs the IP address setting and
other settings.
When using this unit connected to a network with no DHCP function,
make the settings for the IP address, etc., at “Network conntecting
(DHCP=Off)” (vpage30).
NOTE
When setting manually, check the setting contents with the network
administrator.
Network conntecting
1
Connect the LAN cable.
(vpage8 “Connecting to a home network (LAN)”)
2
Turn on this unit.
(vpage11 “Turning the power on”)
3
Press [MENU].
Turns on the Menu settings mode and the Menu appears on
the display. (vpage26 “Menu map”)
4
Use ui to select “Network”-“Connecting”-“DHCP
(Off)”, then press [ENTER/MEMO], <ENTER> or p.
“DHCP Menu” appears.
• When the network connection is set to “DHCP (On)”, go to step 6.
5
Use ui to select “On”, then press [ENTER/MEMO],
<ENTER> or p.
“Connecting” appears.
6
Use ui to select “Connection”, then press [ENTER/
MEMO]
, <ENTER> or p.
The connection starts.
• When the connection is made successfully, “Connection
Succeeded” appears. If the connection fails, “Failed” appears.
NOTE
You may need to set the network connection manually, depending on
the provider you use. To set the connection manually, use the setting
procedure of “Network connecting 'DHCP=Off)”.
Network conntecting (DHCP=Off)
1
Perform steps 1 to 4 of the “Network connecting”
procedure and select “Off” in step 5.
“Manual Setting Menu” appears.
2
Use ui to select “IP Adress”, then press [ENTER/
MEMO]
, <ENTER> or p.
“IP Adress Input Menu” appears.
3
Use uip or [NUMBER] (0 – 9) to input the address
and press [ENTER/MEMO] or <ENTER>.
[Input IP Address]
select move
1 9 2.1 6 8.0 0 0.0 0 
4
Use uip or [NUMBER] (0 – 9) to input the
address for Subnet Mask, Gateway, Primary DNS,
and Secondary DNS.
5
After you input all required addresses, perform
step 6 of “Network connecting” to connect to the
Internet.
Button located on both the main unit and the remote control
BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control [BUTTON]
Symbols used to indicate buttons in this guide
i
u
p
[ENTER/MEMO]
[MENU]
[NUMBER]
<ENTER> u / i
p
1.M-CR603N_ENG_0728.indd 301.M-CR603N_ENG_0728.indd 30 2010/07/29 20:39:272010/07/29 20:39:27