Owner's Manual

Connecting a playback device
You can connect turntables, tuners, Blu-ray disc players, network audio players and CD players to this unit. Use the cartridge selector knob on the front
panel to set the phono equalizer on this unit according to the type of turntable cartridge to be connected. (v p. 8)
If you set this unit’s input source to “PHONO” and you accidentally increase the volume without having a turntable connected, you may hear a hum noise
from the speakers.
NOTE
0
The earth terminal (SIGNAL GND) of this unit is not for safety
grounding purposes. If this terminal is connected when there
is a lot of noise, the noise can be reduced. Note that
depending on the turntable, connecting the ground line may
have the reverse effect of increasing noise. In this case, it is
not necessary to connect the ground line.
0
The PHONO input terminals are equipped with a short pin-
plug. Remove this plug to connect a record player. Store the
removed short pin-plug in a safe place so as not to lose it.
SPEAKERS
RECORDER
AUDIO OUT
PRE OUT
POWER AMP IN
CD TUNER LINE-1 LINE-2 RECORDER
AUDIO IN
GND
AUDIO
OUT
L
R
AUDIO
OUT
LR
AUDIO
OUT
LR
AUDIO
OUT
LR
AUDIO
OUT
LR
L
L
R
R
L
L
R
R
L
L
R
R
L
L
R
R
Turntable
Tu n e r
Blu-ray disc
player
Network audio
player
CD player
Contents Connections Playback Settings Tips Appendix
17
Front panel Rear panel
Remote control
unit
Index