Owner's Manual

Playing CDs
This section uses playback from a CD as an example.
1
Press AMP X to turn the power on.
2
Use INPUT ml to switch the input source to “CD”.
“CD” is displayed on the display.
3
Playback the CD.
4
Use VOLUME no to adjust the volume.
Using this unit as a power amplifier
When connecting a pre-amplifier and using this unit as a power amplifier,
switch the input source of this unit to “PWR AMP”.
1
Turn the INPUT selector on the main unit to switch the
input source to “PWR AMP”.
“PWR AMP” is displayed on the display.
0
When the input source is “PWR AMP”, adjustment of the volume, balance and
tone has no effect. Adjust these adjustments on the pre-amplifier.
0
When the remote control code setting is set to “AMP1” (Default), INPUT ml on
the remote control cannot be used to switch the input source to “PWR AMP” or
switch from “PWR AMP” to another input source. To make remote control
operations, change the remote control code setting to “AMP2” or “AMP3”.
(v p. 31)
NOTE
0
When the input source is “PWR AMP”, the main unit outputs at maximum volume.
Check the output level on the input device before playing it and adjust the volume
accordingly.
Contents Connections Playback Settings Tips Appendix
25
Front panel Rear panel
Remote control
unit
Index