Owner's Manual
Table Of Contents
- Owner’s Manual
- Contents
- Accessories
- Part names and functions
- Connections
- Contents
- Cables used for connections
- Connecting speakers
- Connecting a playback device
- Connecting a recording device
- Connecting to a device with digital audio connectors
- Connecting a USB flash drive to the USB port
- Connecting to a home network (LAN)
- Connecting a pre-amplifier
- Connecting devices with remote control connectors
- Connecting the power cord
- Playback
- Contents
- Basic operation
- Playing CDs
- Listening to music on a Bluetooth device
- Playing digital input
- Getting the HEOS App
- Listening to Internet Radio
- Playing music stored on your mobile
- Playing back files stored on a PC or NAS
- Playing music from a USB flash drive
- AirPlay function
- Spotify Connect function
- Convenience functions
- Settings
- Tips
- Troubleshooting
- Power does not turn on / Power is turned off
- Operations cannot be performed through the remote control unit
- Display on this unit shows nothing
- No sound comes out
- Sound is interrupted or noise occurs
- Desired sound does not come out
- AirPlay cannot be played back
- USB flash drives cannot be played back
- Bluetooth cannot be played back
- The Internet radio cannot be played back
- Music files on PC or NAS cannot be played back (Music server)
- Various online services cannot be played
- Cannot connect to a wireless LAN network
- Audio from digital devices cannot be played back (HDMI ARC/Coaxial/Optical)
- The input source switches to “HDMI ARC”, “Optical” or “Coaxial”
- The HDMI control function does not work
- Update/upgrade error messages
- Restoring the firmware to the factory defaults
- Appendix
Connecting speakers
NOTE
0
Disconnect this unit’s power plug from the power outlet before connecting the
speakers. Also, turn off the subwoofer.
0
Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and - sides touch each other. “Protection circuit” (v p. 105)
0
Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock.
0
Use speakers with an impedance of 4 – 16 Ω/ohms.
Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and - (white)
polarities on the speakers being connected to this unit, and be sure to
connect the channels and polarities correctly.
1
Peel off about 10 mm of sheathing from the tip of the speaker
cable, then either twist the core wire tightly or terminate it.
2
Turn the speaker terminal counterclockwise to loosen it.
3
Insert the speaker cable’s core wire to the hilt into the
speaker terminal.
Contents Connections Playback Settings Tips Appendix
20
Front panel Rear panel
Remote control
unit
Index