Operation Manual

12
General Settings [General]
Language
Setsthelanguagefordisplaythemenu.
•Thedefaultsettingis“English”.
1
Press MENU.
TurnsontheMenusettingsmode
and the Menu appears on the
display (vpage 11 “Menu
map”).
2
Use ui and ENTER to select
“General” – “Language”, then
press ENTER or p.
English
/
Deutsch
/
Français
/
Italiano
/
Nederlands
/
Español
/
Svenska
Auto-Standby
Whenthisunitisinthestopstateandthereisnoinputsignal
and operation for 30 minutes, it automatically enters the
standbymode.
•Thedefaultsettingis“On”.
1
Press MENU.
TurnsontheMenusettingsmode
and the Menu appears on the
display (vpage 11 “Menu
map”).
2
Use ui and ENTER to select
“General” – “Auto-Standby”,
then press ENTER or p.
“Select Auto-Standby” menu
appears.
3
Use ui to select “On” or “O”,
then press ENTER or p.
Thesettingisentered.
NOTE
Inthefollowingsituations,theAuto-Standbyfunctiondoesnot
operate.
•Whenthesourceis“iPod”(Directmode)or“AirPlay”.
Firmware
n Update
•In order to update the rmware, the environment and
settingsrequiredforconnectingtobroadbandinternetare
needed(vpage8).
•Perform the rmware update operation after at least 2
minuteshaselapsedsinceturningthisunit’spowerON.
1
Press MENU.
TurnsontheMenusettingsmode
and the Menu appears on the
display (vpage 11 “Menu
map”).
2
Use ui and ENTER to select
“General” – “Firmware” –
“Update”, then press ENTER or
p.
Check For Update
Checkforrmwareupdates.Youcanalso
checkapproximatelyhowlongitwilltake
tocompleteanupdate.
Update Start
Executetheupdateprocess.
•Ifupdatingfails,thesetautomaticallyretries,butifupdating
isstillnotpossible,oneofthemessagesshownbelowis
displayed.Ifthedisplayreadsasshownbelow,checkthe
settingsandnetworkenvironment,thenupdateagain.
Display Description
Updating fail Updatingfailed.
Login failed Failuretologintoserver.
Server is busy Server is busy. Wait a while then try
again.
Connection fail Failureinconnectingtoserver.
Download fail Downloadingofthermwarehasfailed.
General Settings [General]
Setting the first setup
[Quick Setup]
•For details on “Quick Setup” operations, see the separate
“Getting Started”.
•If you cancelled “Quick Setup” menu or changed the
network environment, perform “Menu” – “Quick Setup”.
Preparation
Operation
Information
Preparation