Model PM7001 / PM7001 KI User Guide Integrated Amplifier PM7001N(Cover) Page 4 05.7.20, 3:58 PM Adobe PageMaker 6.
ENGLISH ESPAÑOL WARRANTY For warranty information, contact your local Marantz distributor. RETAIN YOUR PURCHASE RECEIPT Your purchase receipt is your permanent record of a valuable purchase. It should be kept in a safe place to be referred to as necessary for insurance purposes or when corresponding with Marantz. IMPORTANT When seeking warranty service, it is the responsibility of the consumer to establish proof and date of purchase. Your purchase receipt or invoice is adequate for such proof. FOR U.K.
CE MARKING English The PM7001 is in conformity with the EMC directive and low-voltage directive. Français Le PM7001 est conforme à la directive EMC et à la directive sur les basses tensions. Deutsch Das Modell PM7001 entspricht den EMC-Richtlinien und den Richtlinien für Niederspannungsgeräte. Nederlands De PM7001 voldoet aan de EMC eisen en de vereisten voor laag-voltage. Español El PM7001 está de acuerdo con las normas EMC y las relacionadas con baja tensión.
Español ADVERTENCIAS - No exponga el equipo a la lluvia ni a la humedad. - No extraiga la tapa del equipo. - No introduzca nada en el interior del equipo a través de los orificios de ventilación. - No maneje el cable de alimentación con las manos mojadas. - No cubra la ventilación con objetos como manteles, periódicos, cortinas, etc. - No deben colocarse sobre el equipo elementos con fuego, por ejemplo velas encendidas.
ENGLISH CONTENTS BEFORE USE ........................................................................................................................................ 1 FEATURES ............................................................................................................................................ 2 BEFORE MAKING CONNECTIONS ..................................................................................................... 3 WIRING SPEAKER CABLE .........................................
ENGLISH BEFORE USE This section must be read before any connection is made to the mains supply. 7 Do Not Touch Hot Spots During and Immediately After Use 7 EQUIPMENT MAINS WORKING SETTING During and immediately after use, the PM7001 is hot in areas other than the controls and rear panel connection jacks. Do not touch hot spots and especially the top panel. Contact with hot areas can cause burns.
ENGLISH FEATURES INTEGRATED AMPLIFIER PM7001 INPUT SELECTOR VOLUME PHONO CD TUNER AUX/DVD 1 RECORDER 2 MUTE STANDBY REC SELECTOR OFF POWER ON/OFF TUNER PHONES AUX/DVD BASS TREBLE BALANCE MIN 1 CD MAX SPEAKERS 2 SOURCE DIRECT PHONO ON OFF RECORDER 2 1 ON OFF COPY RECORDER2 1 2 - + The PM7001 is an integrated amplifier developed on the design concepts of Marantz’s PM-11S1 high-end model amplifier.
WIRING SPEAKER CABLE • Be careful not to short circuit in wiring speaker cables. • Peel off the corting of speaker cable as shown below. Approx. 1 cm Cut the corting of cable. Peel off the edge of cable. Twist conductors. Insert conductor of cable. BI-WIRING CONNECTION A bi-wiring connection separately connects the low and mid/ high jacks of the speaker to the amplifier using separate speaker cables.
ENGLISH CONNECTIONS Connection Example : Basic Connection for Stereo Playback Refer also to the instruction manuals of components to connect equipment correctly. Record Player To LINE OUT jacks CD player PRE OUT PHONO GND L SPEAKERS MAIN IN L L R R To LINE OUT jacks R CD Tuner TUNER AUX / DVD RECORDER 1 IN OUT L RECORDER 2 IN OUT L SYSTEM 1 OR SYSTEM 2 4 -16 OH SYSTEM 1 AND SYSTEM 2 8 -16 O SEPARATE R To LINE OUT jacks ON DVD Player To LINE OUT jacks CD-R, etc.
ENGLISH CONNECTIONS Main-amplifier Speaker Speaker If you have another mainamplifier, you can use the PM7001 as the pre-amplifier by connecting as shown in the diagram below. POWER ON/OFF To input jacks To power outlet PHONO PRE OUT SPEAKERS MAIN IN R GND L L L R R SYSTEM 1 L MODEL NO. PM7001 R AC IN SYSTEM 2 SERIAL NO.
ENGLISH NAMES AND FUNCTIONS OF PARTS FRONT PANEL qw e r t y u INTEGRATED AMPLIFIER PM7001 INPUT SELECTOR VOLUME PHONO CD TUNER AUX/DVD 1 RECORDER 2 MUTE STANDBY REC SELECTOR BASS TREBLE BALANCE MIN OFF POWER ON/OFF PHONES TUNER 1 CD MAX SPEAKERS 2 SOURCE DIRECT PHONO AUX/DVD ON OFF RECORDER 2 1 COPY ON OFF RECORDER2 1 2 - !4 !3 !2 q POWER ON/OFF button Pressing this button once turns power to the amplifier ON, and pressing it again turns power to the amplifier OFF.
!3 Infrared Receptor Window !4 PHONES jack This is the receptor of control signals sent from the RC4001PM remote controller. Point the remote controller towards this window to properly transmit signals. This jack is for connecting headphones with a standard stereo plug. To listen with headphones, turn the speaker output OFF by setting the SPEAKERS 1 and 2 buttons o in the OFF position. REAR PANEL B CD A PRE OUT PHONO E SPEAKERS MAIN IN R GND L L L R R F SYSTEM 1 L MODEL NO.
ENGLISH NAMES AND FUNCTIONS OF PARTS RC4001PM REMOTE CONTROLLER Using this remote controller, you can control the PM7001 and Marantz CD players, DVD players, tuners, tape decks etc. that have a remote control receptor. The operations possible by remote controller may differ with each component; therefore see the instruction manual that came with the component. (See page 13) The RC4001PM remote controller buttons are laid out as shown below.
7 CD 7 DVD When the CD button x is pressed, the buttons in group v function as indicated in the table below. These buttons can only be used when a Marantz CD player is connected to the CD input jacks M. When the DVD button x is pressed, the buttons in group v function as indicated in the table below. These buttons can only be used when a Marantz DVD player is connected to the AUX/DVD input jacks K.
ENGLISH NAMES AND FUNCTIONS OF PARTS 7 For use of Remote controller 7 Operatable range of Remote controller Operate the remote controller (RC4001PM) within a distance of approx. 5m from the infrared receptor window on the front of the PM7001. • Loading batteries Before using the remote controller for the first time, load the batteries in the remote controller. The batteries provided are used to verify the operations of the remote controller only. 1.
PLAYBACK ENGLISH BASIC OPERATION RECORDING To explain how to play back input sources, representative examples are given with an CD player and analog record player. Before starting either procedure, check the component is correctly connected to the PM7001. This example explains how to record from an input source such as an CD player to a recording device such as a CD-R. 7 Disc Playback on an CD Player 2. Press the POWER ON/OFF switch q to activate power to 1.
ENGLISH HOW TO USE AND SET FEATURES MAIN IN JACKS You can separate the pre-amplifier section and main-amplifier section by using the SEPARATE switch settings on the PM7001. If you have another pre-amplifier, you can use the PM7001 as the main-amplifier by connecting as shown in the diagram below. Pre-amplifier To PRE OUT Jacks To power outlet Set the SPEAKERS 1 and 2 button on the front panel to the ON position. PHONO PRE OUT SPEAKERS MAIN IN R GND L L L R R SYSTEM 1 L MODEL NO.
ENGLISH HOW TO USE AND SET FEATURES REMOTE CONTROL JACKS The REMOTE CONTROL jacks are for connecting components that are capable of remote control (D.BUS jacks) such as a Marantz CD Player or DVD Player. This enables these other components to be operated with the remote controller included with the PM7001. The PM7001 comes with an RC4001PM system remote controller that can operate the basic features of Marantz CD Players and DVD Players.
ENGLISH TROUBLESHOOTING 7 Before considering it as a failure In case of trouble with this component, first check the following before calling for service. What seems to be a serious malfunction is often due to a simple operation mistake. If the trouble is not fixed after making the following checks, contact the place of purchase, your nearest Marantz dealer, our customer service center, or our repair service center. * Power does not turn ON. 1. Is the power cable plugged securely into the power outlet? 2.
The section describes the care and maintenance tasks that must be performed to optimize the operation of your Marantz component. 7 Cleaning of equipment external surfaces The exterior finish of your unit will last indefinitely with proper care and cleaning, Never use scouring pads, steel wool, scourging powders or harsh chemical agents (e.g., lye solution), alcohol, thinner, benzine, insecticide or other volatile substances as these wil mar the finish of the equipment.
www.marantz.com You can find your nearest authorized distributor or dealer on our website. U.S.A. Marantz America, Inc. 1100 Maplewood Drive, Itasca, IL 60143, U.S.A. EUROPE Marantz Europe B.V. P.O. Box 8744, 5605 LS Eindhoven, The Netherlands is a registered trademark. Printed in China PM7001N(Cover) 07/2005 00M14AJ851310 mzt-d Page 5 05.7.20, 3:58 PM Adobe PageMaker 6.
