Operation Manual
11
ENGLISH
DISPLAY
The display of the receiver is divided into 3 sections, which
are to be used for the following:
Speaker diagram
A rectangle with a letter in it shows that a speaker has been
selected in the setup menu. However, the subwoofer indicator
will only light when a subwoofer signal is available. If only a
letter is shown, this speaker is not used and its sound is
reproduced by the other speakers.
......virtual 3D surround
SURROUND ................surround sound is reproduced
DIGITAL SURROUND ....digital surround sound is reproduced
L, R ..........................front left and right speaker
C ..............................center speaker
SL, SR.......................surround speakers
SW............................subwoofer
Menu indication
These signs show you if the menu is on or off and indicate in
which direction you may move.
MMEENNUU .......................Menu is on.
............................You may move backwards to the
previous menu topic using
PREV. (“left” key on the remote control).
............................You may move up in an option list
using MENU NAVIGATOR (“up” key on
the remote control).
............................You may move down in an option list
using MENU NAVIGATOR (“down” key
on the remote control).
............................You may move forward to the next menu
topic using NEXT (“right” key on the
remote control).
OOKK............................You may confirm the displayed value.
Status lights
Signs showing you various settings and information about the
status of the receiver.
PRESET .....................Tuner is tuned to a preset radio station.
SENS HI.....................Tuner is switched to high sensitivity.
SENS LO....................Tuner is switched to low sensitivity.
STEREO.....................An FM station is being received in stereo.
SMART SOUND ...........One of the preset sound settings of the
receiver is being used.
HALL.........................HALL effect is on.
ANA ..........................Analogue input is being used for the
playing source.
NNIIGGHHTT .......................NIGHT MODE is on.
COAX 1 .....................Coaxial digital input COAX 1 is being
used for the playing source.
COAX 2 ....................Coaxial digital input COAX 2 is being
used for the playing source.
DDOOWWNNMMIIXX..................Incoming multi channel signals are being
reduced to fewer output signals
(depending on the number of speakers).
OPT ..........................Optical digital input OPTICAL IN is being
used for the playing source.
LOUDNESS.................LOUDNESS is switched on.
Information area
This area is used for feedback of the receiver, tuner
frequencies, menu options, values and scrolling text
messages.
+
-
TV VOL
VOL
NEWS T/A
+
-
OK
MENU
0
Display
SR4000U(Eng) DFU 00.8.6 0:41 PM ページ11