Operation Manual
8
ENGLISH
REMOTE CONTROL RANGE
The distance between the transmitter of the remote control unit and
the IR SENSOR of the SR6300 should be less than about 5 meters. If
the transmitter is pointed to a direction other than the IR SENSOR or if
there is an obstacle between them, remote control may not be
possible.
Remote-controllable range
LOADING BATTERIES
The life of the batteries used with the remote control unit is about 4
months with normal use. Also be sure to replace batteries earlier when
you notice that they are getting weak.
1.
Remove the back cover.
2.
Insert the new batteries (AA type) with correct (+) and (–) polarity.
3.
Close until it clicks.
Note:
• The supplied batteries are shipped to confirm the initial
operation. Therefore, the supplied batteries will be consumed
quickly.
Remote control unit (RC7300SR)
SR6300
60°
Approx. 5 m
GENERAL INFROMATION OF RC7300SR
TO SR6300
To control the SR6300 by your RC7300SR, you have to select the
device AMP by function selector button. Please refer as below for the
details in AMP mode.
POWER ON/OFF Turns the SR6300 on and off
POWER ON Turns the SR6300 on
POWER OFF Turns the SR6300 off
EQ Turns on or off HT-EQ mode
7.1/6.1 IN Selects the 6.1CH IN
SLEEP Sets the sleep timer function
A/D Switches between the analog and digital inputs
DISP./RDS Changes the brightness of the front display
Surround mode Selects the surround mode
(0-9)
S-DIRECT Selects the Source Direct mode
NIGHT(+10) Turns on or off NIGHT mode
MUTE Decreases the sound temporarily
BASS
34
Adjusts the tone control of low frequency sound
TREBLE
34
Adjusts the tone control of high frequency sound
VOL
34
Adjusts the over all sound level
MENU/OSD Displays the current setting on the monitor
Cursor Moves the cursor for setting in “On screen display” mode
OK • Enter the “On screen display”
• Confirms the setting in “On screen display” mode
SETUP
Same as OK button
CH SEL
Calls up SETUP MAIN MENU and adjusts speaker levels or 6.1ch input level
TEST Enters the test tone menu
EXIT Exits from SETUP MAIN MENU
SPKR A/B Selects the speaker system
ATT Reduces the input level
Function selector Selects a particular source component