Operation Manual

22
ENGLISH
SETTING THE SLEEP TIMER
Set the sleep timer while the power is turned on.
1. Turn the power ON and press the SLEEP button o / ‹2.
2. Press the SLEEP button o / ‹2 the number of times to set the
desired sleep time in minutes.
Each press of the SLEEP button o / ‹2 or changes the display in
the following order:
The unit will shut off in the number of minutes indicated.
* While the sleep timer is activated, the remaining time can be
displayed for approximately 2 seconds by pressing the SLEEP
button o / ‹2.
* To cancel the Sleep timer, press the SLEEP button o / ‹2 until the
display shows to “SLEEP OFF” and the SLEEP indicator disappear.
ADJUSTING THE SURROUND LEVEL
Adjust the volume level of speakers depend on your preference.
1. Press the CH SEL button ⁄6 in the AMP mode on the remote
controller.
“SURROUND” will be displayed.
2. To select a desired speaker channel with or cursor button.
3. Adjust the volume level of speaker with press or cursor
buttons.
4. To exit from surround menu, press the CH SEL button ⁄6 again,
or move cursor to “EXIT” with or cursor button and press OK
button.
Note:
• When 6.1CH INPUT function is turned on, it will display “6.1
CH INPUT LEVEL” by presssing the CH SEL button ⁄6.
10 20 30
(OFF) 90 80
40
70
50
60
4 SURROUND
SURR . MODE : AUTO
HT - EQ : OFF
LFE LEVEL : 0 dB
CENTER : 0 dB
SURR . R : 0 dB
SURR . C : 0 dB
SURR . L : 0 dB
SUB W : 0 dB
MA I N E X I T