Operating instructions

ManualsBrandsMarantz ManualsDVD-playersSR2100

MAKING CONNECTIONS / SETTING UP THE PLAYER

ENGLISH

Setting Up the

Player

Using the Setup Navigator

The Setup Navigator has been designed to simplify the

process of getting the DVD player ready to perform.

Designed as a series of on-screen multiple-choice questions,

the Setup Navigator automatically sets the audio, video, and

language settings according to how the questions are

answered. Once this procedure is complete, it will be

possible to begin using the DVD player to enjoy DVDs.

The procedure on this page describes the operations

necessary to function within the Setup Navigator screens. A

detailed description of the contents of each question that

appears on the screen can be found on the following pages.

When setting up for the first time

Some DVDs start playing automatically when loaded in the

player. Because the Setup Navigator cannot be used if a disc

is playing, it is recommended to set up the player using the

Setup Navigator before loading a DVD for the first time. If a

DVD has been loaded, be sure to press STOP

7 before

proceeding.

1 Open the Door Panel by hand.

2 Press Power switch on the front panel.

• Press the POWER switch on the Front panel to turn

the power on, and press it again to turn the power off.

Note

When it is required to remote control the power mode of this DVD

player, be sure to leave this switch in the power on mode.

3 Press SETUP.

When SETUP is pressed for the first time, the following

screen appears. Though the Setup Navigator may be

used more than once, this screen only appears the first

time SETUP is pressed.

4 Use the cursor buttons (

5/∞) to make a

selection.

• If you are going to use the Setup Navigator, it is not

necessary to change the setting on the first screen.

Please proceed to the next step.

• If you do not want to set up the player using the

Setup Navigator, use the cursor button (∞) to

select [Auto Start Off] at this time.

The Setup Navigator function may still be used at a

later time in manual Setup screen menu operation

(page 23).

5 Press ENTER.

The selection is entered and the next Setup Navigator

screen appears.

Use steps 4 and 5 as a basis for entering selections on the all

of the Setup Navigator screens described on the following

pages.

To change the answer to a prior question

Use the cursor button (2) to return to previous screens.

Please note, however, that you cannot go forward using the

cursor button (3), so it will be necessary to answer all the

questions that occur after the screen that was returned to.

To exit the Setup Navigator

Press SETUP while on any of the screens to exit the Setup

Navigator. Please note that if the Setup Navigator is exited

before all the questions are answered, no settings are

changed.

To return to the Setup screen

Press RETURN. The Setup Navigator is exited and the Setup

screen General menu screen appears. Please note that no

settings are changed if RETURN is pressed before the Setup

Navigator is finished.

Audio1 Audio2 GeneralLanguageVideo

Setup Navigator

Move

Exit

SETUP

Select

ENTER

Setup Navigator

Auto Start Off

Start

DIMMER

ENTER

RETURN

T-C

+10

RANDOMREPEAT

TOP

AUDIO

SUBTITLE

ANGLE

OSDPROGRAM

SETUP

LAST

MEMORY

CONDITION

MEMORY

CLEAR

987

654

321

A-B

TRAY

OPEN/CLOSE

REMOTE CONTROLLER

RC2100DV

DOOR

SYSANAMANU OPTSYNC RANDTRKPROGSCAN REPT ALL A

BDIG

REM TITL TIME TIMETRK CHP TOTL TOTLREM REM STEPTRK

DOWN MIXANGLE LAST MEMO

Dolby V

96kHz 5.1CH CONDITIONOSD

DUBBING

RW CD