Model SR4021 User Guide Receiver
IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
12. Grounding or Polarization – This product may be equipped with a polarized alternatingcurrent line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. 16.
FOREWORD ...........................................1 INTRODUCTION ....................................1 PRECAUTIONS ......................................1 FEATURES .............................................2 ACCESSORIES ......................................2 FRONT PANEL ......................................3 FL DISPLAY ........................................................................4 REAR PANEL .........................................5 REMOTE CONTROL OPERATION .......
ENGLISH FEATURES ACCESSORIES ■ High quality full discrete power amplifier Check the supplied accessories. 80W+80W (8 ohms, 20 Hz – 20 kHz, 0.08% THD) Remote control unit (RC4021SR) ■ Speaker 1/2 switching You can switch the speaker 1/2 via remote control unit.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 CLEAR button y !6 MEMORY button RECEIVER SR4021 VOLUME u SPEAKERS 2 DISPLAY OFF DOWN CLEAR MEMORY BASS SLEEP BAND TREBLE F/P AUTO TUNE BALANCE SPEAKERS 1 UP T-MODE 2 DIMMER SOURCE DIRECT MUTE RECORDER PHONO STANDBY POWER ON/OFF CD TUNER 1 2 AUX VCR DSS DVD PHONES i 19 18 POWER switch and STANDBY indicator When this switch is pressed once, the unit turns ON and the display is illuminated.
ENGLISH FL DISPLAY a TUNED indicator e Frequency/Character display This indicator illuminates when a station is being received with sufficient signal strength to provide acceptable listening quality. This displays the selected station frequency or the corresponding words when selecting a program source. b f STEREO indicator This indicator illuminates when an FM station is being tuned in stereo condition.
1 2 3 7 4 5 6 AC IN ENGLISH , REAR PANEL Connect to supplied an AC power cord, and connect to an AC power outlet. SR4021 has to be powered by 120V AC only. 8 . Speaker terminals Connect your speaker system(s) to these terminals. There are two sets of terminals, so you can connect either 1 and/or 2 speaker systems. ANTENNA AC OUTLETS 120V VIDEO AM AUX IN DSS IN DVD IN VCR IN OUT MONITOR OUT FLASHER IN GND 60Hz AC IN UNSWITCHED 1.25A 150W REMOTE CONTROL IN ⁄0 SWITCHED 1.
ENGLISH FUNCTION AND OPERATION REMOTE CONTROL OPERATION The provided remote control unit can be used to control a Marantz audio/visual component such as a DVD player, CD player. The POWER button, numeric buttons and control buttons are used in common across different input source components. The input source controlled with the remote control unit changes when one of the input selector buttons on the remote control unit is pressed.
CD RECORDER 1 RECORDER 2 VCR (CDR) (TAPE) SOURCE POWER POWER ON/ POWER ON/ POWER ON/ POWER ON/ STANDBY STANDBY STANDBY STANDBY CHANNEL/SKIP S PREV PREV PREV CHCHANNEL/SKIP T NEXT NEXT NEXT CH+ T-DISP. ; PAUSE PAUSE PAUSE PAUSE PTY 2 PLAY PLAY PLAY PLAY TUNE/SEARCH Q FR FR FR FR TUNE/SEARCH R FF FF FF FF REC 0 REC REC REC BAND 9 STOP STOP STOP STOP Cursor Cursor ENTER OK SETUP INFO MENU 0-9 +10 AUDIO SUBTITLE F.DIR/ANGLE CLEAR MEMO/PROG.
ENGLISH FUNCTION AND OPERATION CONNECTIONS REMOTE CONTROL CODE SETTING The remote control unit contains 3 sets of remote control codes, and it can be used to control up to 3 receivers in one location. To control a second or third receiver, select the remote control code as explained below. The selected receiver can be operated from the remote control. • When the unit is shipped from the factory, the main unit and remote control are set to RECEIVER1. 1.
Graphic equalizer or processor Turn table OUT ANTENNA ENGLISH CONNECTING PRE OUT/MAIN IN JACKS CONNECTING AUDIO COMPONENTS IN L L R R AM AUX IN GND R L FM (75 GND R L ) AUDIO PHONO IN IN OUT IN OUT IN IN L CD player L R R CD RECORDER 1 (CD-R) RECORDER 2 (TAPE) L R AUX VIDEO DVD IN IN VCR OUT MONITOR OUT REMOTE CONTROL IN CD recorder OU Tape Deck IN DVD The output audio signal from the RECORDER 1 OUT jack and the RECORDER 2 OUT jack is the same signal which is curre
ENGLISH CONNECTING VIDEO COMPONENTS CONNECTING THE REMOTE CONTROL JACKS VCR Monitor ANTENNA VIDEO AM AUX IN DVD IN DSS IN IN VCR OUT MONITOR OUT REMOTE CONTROL IN GND AUDIO OUT L R AUDIO VIDEO IN OUT IN OUT FM (75 GND ) VIDEO IN L R AUDIO CVBS PHONO IN IN OUT IN OUT IN IN IN AUX DSS DVD IN OUT IN L L R L R R CD L R RECORDER 1 (CD-R) RECORDER 2 (TAPE) VCR PRE OUT MAIN IN L R REMOTE CONTROL ANTENNA VIDEO AM AUX IN DSS IN DVD IN IN VCR OUT MONITOR OUT R
AM Loop Antenna FM External Antenna FM Antenna ANTENNA AM External Antenna Connecting the supplied AM loop antenna The supplied AM loop antenna is for indoor use only. Set it in the direction and position it to where you receive the clearest sound. Put it as far away as possible from the unit, televisions, speaker cables, and power cords. If you experience poor reception quality, an outdoor antenna may improve the quality.
ENGLISH ADJUSTING THE MAIN VOLUME BASIC OPERATION ADJUSTING THE TONE (BASS & TREBLE) AND BALANCE CONTROL TEMPORARILY TURNING OFF THE SOUND (PLAY BACK) VOLUME VOLUME RECEIVER SR4021 MULTI JOG SELECTING AN INPUT SOURCE DOWN 1 UP DOWN SPEAKERS T-MODE DISPLAY OFF CLEAR MEMORY BAND F/P 2 Before you can listen to any input media, you must first select the input source on the SR4021.
RECORDING A SOURCE In normal operation, the audio or video source selected for listening through the SR4021 is sent to the record outputs. This means that any program you are watching or listening to may be recorded simply by placing machines connected to the outputs for RECORDER1 OUT, RECORDER2 OUT, and VCR OUT in the record mode. To program the SR4021 for automatic standby, press the SLEEP button on the front panel or press the SLEEP button on the remote.
ENGLISH BASIC OPERATION (TUNER) LISTENING TO THE TUNER (Using the remote control unit) 1. 2. Press the TUNE / SEARCH Q or R button more than 1 second on the remote. 3. AUTO TUNING 2. 1. 2. DIRECT FREQUENCY CALL To select the tuner and desired band (AM or FM), press BAND button. (FM) TUNING MODE (AUTO STEREO OR MONO) 1. 1 SPEAKERS 2 DISPLAY OFF CLEAR Automatic searching begins then stops when a station is tuned in. 3. If tuning does not stop at the desired station, use manual tuning.
You can preset up to 30 AM/FM stations in any order. For each station, you can memorize the frequency and reception mode if desired. RECALLING A PRESET STATION 2. 4. 1. RECEIVER SR4021 1. MULTI JOG 1 1 SPEAKERS SPEAKERS 2 AUTO PRESET MEMORY CLEAR 4. 3. 1. MEMORY BASS 3. PHONO DISPLAY OFF CLEAR TREBLE DIMMER STANDBY WER ON/OFF CD TUNER PHONES RECEIVER SR4021 2. SLEEP VOLUME RECORDER F/P AUTO TUNE BALANCE T-MODE SPEAKERS 1 2 DIMMER MUTE 2.
ENGLISH CLEARING STORED PRESET STATIONS NAME INPUT OF THE PRESET STATION You can remove preset stations from the memory using the following procedure. This function allows the name of each preset channel to be entered using alphanumeric characters. Before inputting names, you need to store preset stations with the preset memory operation. 3. 2. 4. ER SR4021 5. Note: Unused columns should be filled by entering blanks. 3. 2. 5. 6. 6.
In case of trouble, check the following before calling for service: 1. 2. 3. Are the connections made properly ? Are you operating the unit properly following the user’s guide ? Are the power amplifiers and speaker working properly ? If the unit does not operate properly, check items shown in the following table.
DIMENSIONS FM TUNER SECTION 13-11/16 ins. (342.5 mm) Frequency Range ................................ 87.5 – 108.0 MHz Usable Sensitivity .............................IHF 2.0 µV/17.3 dBf Signal to Noise Ratio ................... Mono/Stereo 70/65 dB Distortion.......................................Mono/Stereo 0.2/0.3% Stereo Separation .........................................1 kHz 40 dB A.C.S ......................................................±300 kHz 50 dB Image Rejection ...........................
www.marantz.com You can find your nearest authorized distributor or dealer on our website. is a registered trademark.