Owner`s manual
119
Registering preset codes
When preset codes are registered in the included remote control unit,
it can then be used to operate any devices you have, such as DVD
players or TVs made by different manufacturers.
NOTE
•No preset codes other than BD, DVD, SAT and TV can be registered.
•In the factory settings, remote control codes for all marantz products
are registered.
nButtons used for operating the devices
q SOURCE Z / X
For switching power of each device on or off.
w uio p, ENTER
For menu operation of each device.
e MENU, SHIFT/TOP MENU
For displaying the menu of each device.
r 3, 1, 2, 8, 9, 6, 7
t Number button (0 – 9, +10)
y PRESET +, PRESET –
u TV Z / X, TV INPUT
For operating a TV
This button is enabled in any mode.
For details on operation with the remote control unit, see pages
31,33,37,43,44,47,46,49,121,122.
Registering preset codes
The following two methods can be used for registering the reset code.
q Entering a 4-digit code
w Scanning the code table
q Entering a 4-digit code
See the preset code list table for the code to be input.
1
Press and hold down the input
source select buttons for the
appliance to control, and press
SET until the SEND indicator
blinks.
2
Press the 4-digit code for the
appliance using 0 - 9 (code table
at the end of this manual).
When the procedure is successful, the
LEARN indicator blinks twice.
NOTE
If the LEARN indicator did not blink twice,
then repeat steps 1 and 2 and try entering
the same code again.
w Scanning the code table
1
Switch the power of the
appliance to which you want to
register the preset code to ON.
2
Press and hold down the input
source select buttons for the
appliance to control, and press
SET until the SEND indicator
blinks.
3
Aim the remote control at the
appliance and slowly alternate
between pressing SOURCE d and
SOURCE Z /X for the appliance.
4
When the power of the appliance
that you want to register has
turned off, release the button.
5
Press ENTER.
When the procedure is successful, the
LEARN indicator blinks twice.
Basic version
Advanced version
Information
Advanced version
vSee overleaf