Owner`s manual

67
Connecting the RS-232C connector
When you connect an external control device, you can control this unit
with the external control device.
External serial controller
Perform the operation below beforehand.
q Turn on the power of this unit.
w Turn off the power of this unit from the external controller.
e Check that the unit is in the standby mode.
Connecting the DC OUT (TRIGGER
OUT) jacks
When a device with DC IN jack is connected, the connected device’s
power on/standby can be controlled through linked operation to this
unit.
The DC OUT jack outputs a maximum 12 V/150 mA electrical signal.
12 V/150 mA trigger-compatible device
Set to change the conditions for linked operation via the DC OUT
1 or 2 jack.
“Trigger Out 1” or “Trigger Out 2” (vpage113)
in Set as Necessary
NOTE
•Use the monaural mini-plug cable for connecting DC OUT jacks. Do
not use the stereo mini-plug cable.
•If the permissible trigger input level for the connected device is
larger than 12 V/150 mA, or has shorted, the DC OUT jack cannot be
used. In this case, turn off the power to the unit, and disconnect it.
Basic version
Advanced version
Information
Advanced version